Conversion from 10 Megaoctets per second to Tebibits per second

Information about the Megaoctet per second (Mo/s)

The megaoctet per second is a unit of data transfer rate equal to one million octets per second, or eight megabits per second. Its symbol is Mo/s. It is the unit in which storage devices and their interfaces are rated, and the one a file manager shows while a copy is running.

Storage speeds fall naturally into this range. A mechanical hard drive sustains 100 to 250 megaoctets per second on sequential reads. A solid-state drive on the older interface reaches about 550, which is the limit of that interface rather than of the drive. A modern drive on the faster interface reaches several thousand, at which point the unit gives way to gigaoctets per second.

Interface speeds tell the same story from the other side. The successive versions of the universal serial bus have offered roughly 1.5, 60, 625 and 2,500 megaoctets per second at their nominal rates, and memory card standards have followed a similar path. A device is always limited by whichever of the two is slower, and matching them is the practical art of building a fast system.

For everyday sizes, one megaoctet per second transfers a photograph in a couple of seconds and a two-gigaoctet film in about half an hour. At 500 megaoctets per second the same film takes four seconds. That contrast explains why the perceived speed of a computer changed so completely when solid-state storage replaced mechanical drives, even though processors improved far less over the same period.

Sequential rates like these are the best case. Reading many small files instead of one large one costs far more, because each file requires locating its data and reading its record. A drive that sustains 500 megaoctets per second in sequence may manage only a few tens when copying a directory of thousands of small files, and that is where the difference between drive technologies is most visible.

The unit also describes the throughput of a busy network connection: a gigabit link delivers 125 megaoctets per second at best, so a fast local network and a fast drive are now comparable, and neither is obviously the limiting factor in a transfer.

One megaoctet per second equals 1,000,000 octets per second, 8 megabits per second, or about 0.9537 mebioctets per second.

Information about the Tebibit per second (Tibit/s)

The tebibit per second is a unit of data transfer rate equal to 1,099,511,627,776 bits per second, which is 1,024 gibibits per second. Its symbol is Tibit/s. It is the binary counterpart of the terabit per second, and the two differ by 10 per cent.

Ten per cent is the point at which the distinction becomes a matter of money rather than of pedantry. A supplier quoting a system at a hundred terabits per second and a customer measuring a hundred tebibits per second are not describing the same performance, and the difference is ten terabits — more than most organisations' entire external connectivity.

The rate belongs to the interior of very large machines. The aggregate memory bandwidth of a rack of accelerators, or the internal switching capacity of a large network chip, reaches this range, and both are built from power-of-two structures: memory channels of fixed binary width, switch ports in powers of two, buffers sized in binary. Expressing their totals with binary prefixes preserves the arithmetic that produced them.

In octets a tebibit per second is 137,438,953,472, or 128 gibioctets per second. That is more than any single storage device can supply and more than any external cable carries. It is a figure that describes something happening inside a cabinet, between chips connected by short traces on a board, where the physical distance is measured in centimetres.

Optical research also brushes this range. A laboratory demonstration carrying a petabit per second down one fibre is a thousand times higher, but individual wavelength channels and the electronics driving them work at tebibit-scale aggregates, and papers reporting them often state the binary figure because the underlying frame sizes are binary.

The habit of writing the lowercase i is worth keeping even where the reader is unlikely to check. A number written unambiguously can be converted correctly by anyone who reads it later; one written ambiguously cannot be repaired, and at ten per cent the ambiguity is no longer harmless.

One tebibit per second equals 1,024 gibibits per second, 137,438,953,472 octets per second, or about 1.100 terabits per second.