Conversion from Megaoctets per second to Octets per second

Information about the Megaoctet per second (Mo/s)

The megaoctet per second is a unit of data transfer rate equal to one million octets per second, or eight megabits per second. Its symbol is Mo/s. It is the unit in which storage devices and their interfaces are rated, and the one a file manager shows while a copy is running.

Storage speeds fall naturally into this range. A mechanical hard drive sustains 100 to 250 megaoctets per second on sequential reads. A solid-state drive on the older interface reaches about 550, which is the limit of that interface rather than of the drive. A modern drive on the faster interface reaches several thousand, at which point the unit gives way to gigaoctets per second.

Interface speeds tell the same story from the other side. The successive versions of the universal serial bus have offered roughly 1.5, 60, 625 and 2,500 megaoctets per second at their nominal rates, and memory card standards have followed a similar path. A device is always limited by whichever of the two is slower, and matching them is the practical art of building a fast system.

For everyday sizes, one megaoctet per second transfers a photograph in a couple of seconds and a two-gigaoctet film in about half an hour. At 500 megaoctets per second the same film takes four seconds. That contrast explains why the perceived speed of a computer changed so completely when solid-state storage replaced mechanical drives, even though processors improved far less over the same period.

Sequential rates like these are the best case. Reading many small files instead of one large one costs far more, because each file requires locating its data and reading its record. A drive that sustains 500 megaoctets per second in sequence may manage only a few tens when copying a directory of thousands of small files, and that is where the difference between drive technologies is most visible.

The unit also describes the throughput of a busy network connection: a gigabit link delivers 125 megaoctets per second at best, so a fast local network and a fast drive are now comparable, and neither is obviously the limiting factor in a transfer.

One megaoctet per second equals 1,000,000 octets per second, 8 megabits per second, or about 0.9537 mebioctets per second.

Information about the Octet per second (octet/s)

The octet per second is a unit of data transfer rate equal to eight bits per second. Its symbol is octet/s. It is the unit in which software reports transfer speeds, as against the bits per second in which hardware and network services advertise them, and the factor of eight between the two conventions is the source of endless confusion.

The division of labour is consistent once it is understood. Anything describing a physical link — an Ethernet port, a fibre connection, a radio channel, a broadband package — is quoted in bits per second, because bits are what the signalling actually carries. Anything describing a file moving from one place to another is quoted in octets per second, because files are measured in octets.

A download manager that reports 12 megaoctets per second on a connection sold as 100 megabits per second is not disagreeing with the advertisement; it is stating the same rate in the other convention, and the arithmetic between them is a division by eight. Recognising this immediately removes the most common cause of complaint about internet speed.

Individual octets per second appear in the same narrow places as individual bits: deep-space telemetry, low-power sensor links, and the slowest legacy serial connections. A rate of a hundred octets per second would move a page of text in about twenty seconds, which was a normal experience in the 1970s and is unimaginable now.

The unit also underlies the way disc and interface throughput is described. A drive that sustains 500 megaoctets per second is moving four gigabits per second across its interface, and matching the two figures is a routine part of system design: an interface rated in gigabits must be compared with a drive rated in octets, and the factor of eight decides whether one starves the other.

Storage tools reinforce the convention. Every file copy utility, backup program and command-line transfer tool reports in octets per second or its multiples, and every network measurement tool reports in bits per second. A person reading both at once has to keep the conversion in mind, which is exactly what makes the distinction worth stating explicitly.

One octet per second equals 8 bits per second, 0.008 kilobits per second, or 0.001 kilooctets per second.