Conversion from Megaoctets per second to Mebioctets per second

Information about the Megaoctet per second (Mo/s)

The megaoctet per second is a unit of data transfer rate equal to one million octets per second, or eight megabits per second. Its symbol is Mo/s. It is the unit in which storage devices and their interfaces are rated, and the one a file manager shows while a copy is running.

Storage speeds fall naturally into this range. A mechanical hard drive sustains 100 to 250 megaoctets per second on sequential reads. A solid-state drive on the older interface reaches about 550, which is the limit of that interface rather than of the drive. A modern drive on the faster interface reaches several thousand, at which point the unit gives way to gigaoctets per second.

Interface speeds tell the same story from the other side. The successive versions of the universal serial bus have offered roughly 1.5, 60, 625 and 2,500 megaoctets per second at their nominal rates, and memory card standards have followed a similar path. A device is always limited by whichever of the two is slower, and matching them is the practical art of building a fast system.

For everyday sizes, one megaoctet per second transfers a photograph in a couple of seconds and a two-gigaoctet film in about half an hour. At 500 megaoctets per second the same film takes four seconds. That contrast explains why the perceived speed of a computer changed so completely when solid-state storage replaced mechanical drives, even though processors improved far less over the same period.

Sequential rates like these are the best case. Reading many small files instead of one large one costs far more, because each file requires locating its data and reading its record. A drive that sustains 500 megaoctets per second in sequence may manage only a few tens when copying a directory of thousands of small files, and that is where the difference between drive technologies is most visible.

The unit also describes the throughput of a busy network connection: a gigabit link delivers 125 megaoctets per second at best, so a fast local network and a fast drive are now comparable, and neither is obviously the limiting factor in a transfer.

One megaoctet per second equals 1,000,000 octets per second, 8 megabits per second, or about 0.9537 mebioctets per second.

Information about the Mebioctet per second (Mio/s)

The mebioctet per second is a unit of data transfer rate equal to 1,048,576 octets per second, which is 1,024 kibioctets per second. Its symbol is Mio/s. It is the unit that disc benchmarks, copy tools and backup programs report in, and one of the few binary units most people see regularly without noticing.

Storage measurement produces it naturally. A benchmark writes and reads blocks whose size is a power of two, times the operation, and divides. The result is a binary rate, and reporting it as such preserves the arithmetic. A tool that converted to decimal megaoctets would introduce a 4.9 per cent adjustment for no purpose other than to match a marketing convention.

That five per cent is exactly where the two conventions diverge visibly for consumers. A drive advertised at 550 megaoctets per second and measured at 524 mebioctets per second is performing precisely as claimed; the numbers differ only because one is decimal and the other binary. A great deal of complaint about storage performance is this arithmetic misread as a shortfall.

For everyday sizes, one mebioctet per second copies a photograph in three seconds and a two-gigaoctet film in about half an hour. Modern drives run hundreds or thousands of times faster, so the unit is now the resolution at which small differences are reported rather than the scale of the whole figure.

The unit also appears in memory and cache measurements, in database throughput reports and in the output of the low-level commands that write disc images. All of these count in binary blocks because the underlying structures are binary, and all of them report in mebioctets per second because that is what the count divided by the time actually gives.

The habit of writing the lowercase i is worth keeping. It costs one character and it tells a later reader which of two conventions produced the number, which is information that cannot be recovered from context once it has been left out.

One mebioctet per second equals 1,048,576 octets per second, 1,024 kibioctets per second, or about 1.049 megaoctets per second.