Conversion from Tebibits per second to Mebioctets per second

Information about the Tebibit per second (Tibit/s)

The tebibit per second is a unit of data transfer rate equal to 1,099,511,627,776 bits per second, which is 1,024 gibibits per second. Its symbol is Tibit/s. It is the binary counterpart of the terabit per second, and the two differ by 10 per cent.

Ten per cent is the point at which the distinction becomes a matter of money rather than of pedantry. A supplier quoting a system at a hundred terabits per second and a customer measuring a hundred tebibits per second are not describing the same performance, and the difference is ten terabits — more than most organisations' entire external connectivity.

The rate belongs to the interior of very large machines. The aggregate memory bandwidth of a rack of accelerators, or the internal switching capacity of a large network chip, reaches this range, and both are built from power-of-two structures: memory channels of fixed binary width, switch ports in powers of two, buffers sized in binary. Expressing their totals with binary prefixes preserves the arithmetic that produced them.

In octets a tebibit per second is 137,438,953,472, or 128 gibioctets per second. That is more than any single storage device can supply and more than any external cable carries. It is a figure that describes something happening inside a cabinet, between chips connected by short traces on a board, where the physical distance is measured in centimetres.

Optical research also brushes this range. A laboratory demonstration carrying a petabit per second down one fibre is a thousand times higher, but individual wavelength channels and the electronics driving them work at tebibit-scale aggregates, and papers reporting them often state the binary figure because the underlying frame sizes are binary.

The habit of writing the lowercase i is worth keeping even where the reader is unlikely to check. A number written unambiguously can be converted correctly by anyone who reads it later; one written ambiguously cannot be repaired, and at ten per cent the ambiguity is no longer harmless.

One tebibit per second equals 1,024 gibibits per second, 137,438,953,472 octets per second, or about 1.100 terabits per second.

Information about the Mebioctet per second (Mio/s)

The mebioctet per second is a unit of data transfer rate equal to 1,048,576 octets per second, which is 1,024 kibioctets per second. Its symbol is Mio/s. It is the unit that disc benchmarks, copy tools and backup programs report in, and one of the few binary units most people see regularly without noticing.

Storage measurement produces it naturally. A benchmark writes and reads blocks whose size is a power of two, times the operation, and divides. The result is a binary rate, and reporting it as such preserves the arithmetic. A tool that converted to decimal megaoctets would introduce a 4.9 per cent adjustment for no purpose other than to match a marketing convention.

That five per cent is exactly where the two conventions diverge visibly for consumers. A drive advertised at 550 megaoctets per second and measured at 524 mebioctets per second is performing precisely as claimed; the numbers differ only because one is decimal and the other binary. A great deal of complaint about storage performance is this arithmetic misread as a shortfall.

For everyday sizes, one mebioctet per second copies a photograph in three seconds and a two-gigaoctet film in about half an hour. Modern drives run hundreds or thousands of times faster, so the unit is now the resolution at which small differences are reported rather than the scale of the whole figure.

The unit also appears in memory and cache measurements, in database throughput reports and in the output of the low-level commands that write disc images. All of these count in binary blocks because the underlying structures are binary, and all of them report in mebioctets per second because that is what the count divided by the time actually gives.

The habit of writing the lowercase i is worth keeping. It costs one character and it tells a later reader which of two conventions produced the number, which is information that cannot be recovered from context once it has been left out.

One mebioctet per second equals 1,048,576 octets per second, 1,024 kibioctets per second, or about 1.049 megaoctets per second.