Conversion from 4 Petabits per second to Megaoctets per second

Information about the Petabit per second (Pbit/s)

The petabit per second is a unit of data transfer rate equal to a thousand terabits per second. Its symbol is Pbit/s. It marks the frontier of optical transmission research: the rate at which laboratories have carried data down a single strand of glass, and which no deployed system yet approaches.

The records were set by combining three techniques. Multi-core fibre puts several separate light-guiding paths inside one cladding, so that a single strand behaves like a bundle. Wavelength division multiplexing runs hundreds of distinct colours down each of those cores. Advanced modulation encodes many bits into each pulse. Multiplying the three together is what reaches a petabit per second.

Such demonstrations run over tens of kilometres of fibre in controlled conditions, not the thousands of kilometres a working sea cable must span. Distance is the hard part: signals attenuate, dispersion smears pulses together, and non-linear effects in the glass grow with power. Every kilometre added makes the same rate harder to sustain, which is why deployed cables sit two orders of magnitude below the laboratory record.

In octets a petabit per second is 125 teraoctets per second, which is roughly the storage of a hundred and twenty-five large hard drives moved every second. Nothing at either end of such a link could produce or absorb data at that rate; the figure describes the medium's capacity rather than any use of it.

At the network level the unit is used for aggregates. The total interconnect capacity of a very large data centre, the summed capacity of all the cables landing on a continent, and the peak traffic of the largest content networks are quoted in petabits per second. These are sums over thousands of links, not the rating of any one.

The trajectory is worth noting. Transoceanic capacity has grown by roughly a factor of ten every seven or eight years for several decades, driven almost entirely by better electronics and better coding rather than by more glass. If that continues, the petabit per second will describe a working cable within a generation.

One petabit per second equals 1,000 terabits per second, 125 teraoctets per second, or about 0.8882 pebibits per second.

Information about the Megaoctet per second (Mo/s)

The megaoctet per second is a unit of data transfer rate equal to one million octets per second, or eight megabits per second. Its symbol is Mo/s. It is the unit in which storage devices and their interfaces are rated, and the one a file manager shows while a copy is running.

Storage speeds fall naturally into this range. A mechanical hard drive sustains 100 to 250 megaoctets per second on sequential reads. A solid-state drive on the older interface reaches about 550, which is the limit of that interface rather than of the drive. A modern drive on the faster interface reaches several thousand, at which point the unit gives way to gigaoctets per second.

Interface speeds tell the same story from the other side. The successive versions of the universal serial bus have offered roughly 1.5, 60, 625 and 2,500 megaoctets per second at their nominal rates, and memory card standards have followed a similar path. A device is always limited by whichever of the two is slower, and matching them is the practical art of building a fast system.

For everyday sizes, one megaoctet per second transfers a photograph in a couple of seconds and a two-gigaoctet film in about half an hour. At 500 megaoctets per second the same film takes four seconds. That contrast explains why the perceived speed of a computer changed so completely when solid-state storage replaced mechanical drives, even though processors improved far less over the same period.

Sequential rates like these are the best case. Reading many small files instead of one large one costs far more, because each file requires locating its data and reading its record. A drive that sustains 500 megaoctets per second in sequence may manage only a few tens when copying a directory of thousands of small files, and that is where the difference between drive technologies is most visible.

The unit also describes the throughput of a busy network connection: a gigabit link delivers 125 megaoctets per second at best, so a fast local network and a fast drive are now comparable, and neither is obviously the limiting factor in a transfer.

One megaoctet per second equals 1,000,000 octets per second, 8 megabits per second, or about 0.9537 mebioctets per second.