Conversion from Gibibits per second to Kilobits per second

=

Invert

Formula to convert Gibibits per second (Gibit/s) to Kilobits per second (kbit/s)

More information

Gibibits per second to Kilobits per second conversion table

Gibibits per second (Gibit/s)Kilobits per second (kbit/s)
1 Gibibit per second1073741.824 kbit/s
2 Gibibits per second2147483.648 kbit/s
3 Gibibits per second3221225.472 kbit/s
4 Gibibits per second4294967.296 kbit/s
5 Gibibits per second5368709.12 kbit/s
10 Gibibits per second10737418.24 kbit/s
20 Gibibits per second21474836.48 kbit/s
25 Gibibits per second26843545.6 kbit/s
50 Gibibits per second53687091.2 kbit/s
100 Gibibits per second107374182.4 kbit/s

Data-transfer rate reference points

ReferenceGibibits per second (Gibit/s)Kilobits per second (kbit/s)
A dial-up modem0.0000521541 Gibit/s56 kbit/s
Typical home broadband0.0931323 Gibit/s100000 kbit/s
Gigabit Ethernet0.931323 Gibit/s1000000 kbit/s
Streaming a 4K film0.0232831 Gibit/s25000 kbit/s

Try our other unit converters

LengthMassTemperatureEnergyVolumeSpeedTimeDataPressureFrequencyData-transfer rateVolumetric flow rateAngleArea

Information about the Gibibit per second (Gibit/s)

The gibibit per second is a unit of data transfer rate equal to 1,073,741,824 bits per second. Its symbol is Gibit/s. It is the binary counterpart of the gigabit per second, and the two now differ by 7.4 per cent, which is enough to matter in any engineering specification.

The unit belongs to the inside of a machine rather than to the network. Memory buses, processor interconnects and the links between chips on the same board all move a power-of-two number of bits per clock cycle, so their throughput is naturally expressed with a binary prefix. A bus sixty-four bits wide clocked at a given frequency delivers a rate that is a binary multiple of that frequency.

Networking, by contrast, is decimal all the way down. Gigabit Ethernet carries exactly one thousand million bits per second, not 1,073,741,824, and the symbol rate on the wire is chosen to make that so. Confusing the two overstates a link's capacity by seven per cent, which in a capacity plan is the difference between adequate and insufficient.

In octets a gibibit per second is 134,217,728, or 128 mebioctets per second. That is close to the throughput of a fast mechanical hard drive and well below a modern solid-state drive, so it sits at the point where storage and internal buses meet and where matching their rates becomes a design question.

Benchmark tools are the commonest place to see the unit written correctly. A memory bandwidth test that allocates buffers in powers of two and measures how long they take to traverse naturally reports in gibibits or gibioctets per second, and a well-written tool says so explicitly rather than rounding to the decimal unit.

The reason to insist on the distinction here rather than lower down the scale is arithmetic. At the kibibit the gap was 2.4 per cent and could be ignored; here it is nearly a thirteenth, and it grows by a further 2.4 per cent at every step above. Getting into the habit at this level costs nothing and avoids compounding errors later.

One gibibit per second equals 1,073,741,824 bits per second, 134,217,728 octets per second, or about 1.074 gigabits per second.


Information about the Kilobit per second (kbit/s)

The kilobit per second is a unit of data transfer rate equal to one thousand bits per second. Its symbol is kbit/s, often written kbps. It was the unit of the dial-up era, and it survives today as the unit in which audio and speech encoding rates are quoted.

The dial-up sequence is worth recalling because each number marks a technical generation. Modems ran at 300 bits per second in the late 1970s, then 1,200, 2,400, 9,600, 14,400, 28,800, 33,600 and finally 56 kilobits per second at the end of the 1990s. That last figure was the ceiling of an ordinary telephone line, set by the eight-kilohertz sampling of the digital telephone network rather than by the modem.

Audio encoding is where the unit now lives. Telephone-quality speech runs at 8 to 64 kilobits per second depending on the codec, with modern low-rate codecs producing intelligible speech at 8 and high-quality voice calls at 24 to 32. Music at 128 kilobits per second was the early standard of portable players, 192 and 256 are common, and 320 is the practical ceiling of the older lossy formats.

Those numbers reward a moment of arithmetic. Music at 128 kilobits per second is 16 kilooctets per second, so a four-minute track is about 3.8 megaoctets. Uncompressed compact-disc audio runs at 1,411 kilobits per second, so the compressed file is about a tenth the size of the original, which is the whole point of the format.

Video subtitle streams, control channels and telemetry links also work in kilobits per second. So does much of the machine-to-machine traffic that fills modern networks: a sensor reporting a reading every few seconds needs a fraction of a kilobit per second, and the protocols designed for such devices are built around keeping the radio switched off most of the time.

The unit's lower-case k marks the decimal kilo, one thousand exactly. In transmission this has never been ambiguous, because network rates have always been counted in true thousands; the binary confusion that afflicts storage units does not arise here, and a kilobit per second means the same thing in every document.

One kilobit per second equals 1,000 bits per second, 125 octets per second, or about 0.9766 kibibits per second.