Conversion from 20 Tebioctets per second to Megaoctets per second

Information about the Tebioctet per second (Tio/s)

The tebioctet per second is a unit of data transfer rate equal to 1,024 gibioctets per second, or two to the fortieth power octets per second. Its symbol is Tio/s. It is the binary counterpart of the teraoctet per second, and the two differ by 10 per cent.

Nothing outside a large machine moves data this quickly. The rate describes the memory bandwidth of an accelerator with stacked memory, the internal fabric of a high-end processor package, or the aggregate throughput of a parallel filesystem spread across thousands of drives. All of these are built from binary structures, and their totals are binary quantities divided by time.

High-performance computing is where the unit is written most often. A supercomputer's storage system is specified by how many tebioctets per second it can deliver to the compute nodes, because that number determines how quickly a simulation can save its state and resume. A machine that computes quickly but writes slowly spends its time waiting.

The ten per cent difference from the decimal unit is significant in that context. A filesystem procured to deliver 10 teraoctets per second and one delivering 10 tebioctets per second differ by a whole teraoctet per second, which in a facility of that size represents a substantial fraction of the hardware budget.

In bits a tebioctet per second is 8 tebibits per second, and in decimal terms about 1.1 teraoctets per second. Expressing the same rate four different ways is routine at this level, because the storage industry, the memory industry, the network industry and the standards bodies each prefer a different one.

For everyday comparison, a tebioctet per second would fill a large consumer hard drive in about twenty seconds. No external interface carries this; the figure describes movement between components inside a single system, where the wires are short and there are very many of them running in parallel.

Graphics processors have brought the rate within reach of a single component. A stack of high-bandwidth memory bonded directly to the processor die delivers well over a tebioctet per second to the chip that uses it, and a card carrying several such stacks passes a few. That bandwidth, rather than raw arithmetic speed, is what limits the training of large models: the arithmetic units sit idle unless the memory can keep them fed. The same reasoning explains why supercomputer designers spend as much effort on the paths between memory and processor as on the processors themselves, and why the rate is quoted in binary units when the memory it describes is addressed in powers of two.

One tebioctet per second equals 1,024 gibioctets per second, 1,099,511,627,776 octets per second, or about 1.100 teraoctets per second.

Information about the Megaoctet per second (Mo/s)

The megaoctet per second is a unit of data transfer rate equal to one million octets per second, or eight megabits per second. Its symbol is Mo/s. It is the unit in which storage devices and their interfaces are rated, and the one a file manager shows while a copy is running.

Storage speeds fall naturally into this range. A mechanical hard drive sustains 100 to 250 megaoctets per second on sequential reads. A solid-state drive on the older interface reaches about 550, which is the limit of that interface rather than of the drive. A modern drive on the faster interface reaches several thousand, at which point the unit gives way to gigaoctets per second.

Interface speeds tell the same story from the other side. The successive versions of the universal serial bus have offered roughly 1.5, 60, 625 and 2,500 megaoctets per second at their nominal rates, and memory card standards have followed a similar path. A device is always limited by whichever of the two is slower, and matching them is the practical art of building a fast system.

For everyday sizes, one megaoctet per second transfers a photograph in a couple of seconds and a two-gigaoctet film in about half an hour. At 500 megaoctets per second the same film takes four seconds. That contrast explains why the perceived speed of a computer changed so completely when solid-state storage replaced mechanical drives, even though processors improved far less over the same period.

Sequential rates like these are the best case. Reading many small files instead of one large one costs far more, because each file requires locating its data and reading its record. A drive that sustains 500 megaoctets per second in sequence may manage only a few tens when copying a directory of thousands of small files, and that is where the difference between drive technologies is most visible.

The unit also describes the throughput of a busy network connection: a gigabit link delivers 125 megaoctets per second at best, so a fast local network and a fast drive are now comparable, and neither is obviously the limiting factor in a transfer.

One megaoctet per second equals 1,000,000 octets per second, 8 megabits per second, or about 0.9537 mebioctets per second.