Conversion from Petaoctets per second to Tebibits per second

Information about the Petaoctet per second (Po/s)

The petaoctet per second is a unit of data transfer rate equal to a thousand teraoctets per second, or eight petabits per second. Its symbol is Po/s. It describes the total internal bandwidth of the largest computing machines rather than any single connection, and it exists as an aggregate rather than as a rate anything can sustain on its own.

The clearest case is the interconnect of an exascale supercomputer. Such a machine has tens of thousands of nodes, each linked to the network at hundreds of gigaoctets per second, and the sum across the whole fabric reaches petaoctets per second. That figure is the reason such machines can run a single calculation spread over the whole system rather than many small independent ones.

Memory bandwidth adds up the same way. A machine with ten thousand accelerators, each with several teraoctets per second of local memory bandwidth, has tens of petaoctets per second in total. Whether that total means anything depends entirely on the calculation: a problem that can be divided so each node works mostly on its own data can use it, and a problem that cannot, cannot.

Data centre networks reach this range too. The aggregate capacity of the switching fabric inside a very large facility, counting every link between every rack, is measured in petaoctets per second. The design goal is that any server can reach any other at close to full speed, which requires far more internal capacity than the facility's external connections.

For scale, a petaoctet per second would transfer the entire contents of a large national archive in a second, or fill every hard drive manufactured in a day within about a minute. No storage system can supply data at this rate, and none can absorb it; the number describes movement inside a machine, between memory and processors, where nothing is being stored at all.

The unit also serves in optical research, where a single fibre carrying a petabit per second is 125 teraoctets per second, and an experimental system aggregating several such fibres approaches the petaoctet. Those figures come from laboratories rather than from anything deployed.

One petaoctet per second equals 1,000 teraoctets per second, 8 petabits per second, or about 0.8882 pebioctets per second.

Information about the Tebibit per second (Tibit/s)

The tebibit per second is a unit of data transfer rate equal to 1,099,511,627,776 bits per second, which is 1,024 gibibits per second. Its symbol is Tibit/s. It is the binary counterpart of the terabit per second, and the two differ by 10 per cent.

Ten per cent is the point at which the distinction becomes a matter of money rather than of pedantry. A supplier quoting a system at a hundred terabits per second and a customer measuring a hundred tebibits per second are not describing the same performance, and the difference is ten terabits — more than most organisations' entire external connectivity.

The rate belongs to the interior of very large machines. The aggregate memory bandwidth of a rack of accelerators, or the internal switching capacity of a large network chip, reaches this range, and both are built from power-of-two structures: memory channels of fixed binary width, switch ports in powers of two, buffers sized in binary. Expressing their totals with binary prefixes preserves the arithmetic that produced them.

In octets a tebibit per second is 137,438,953,472, or 128 gibioctets per second. That is more than any single storage device can supply and more than any external cable carries. It is a figure that describes something happening inside a cabinet, between chips connected by short traces on a board, where the physical distance is measured in centimetres.

Optical research also brushes this range. A laboratory demonstration carrying a petabit per second down one fibre is a thousand times higher, but individual wavelength channels and the electronics driving them work at tebibit-scale aggregates, and papers reporting them often state the binary figure because the underlying frame sizes are binary.

The habit of writing the lowercase i is worth keeping even where the reader is unlikely to check. A number written unambiguously can be converted correctly by anyone who reads it later; one written ambiguously cannot be repaired, and at ten per cent the ambiguity is no longer harmless.

One tebibit per second equals 1,024 gibibits per second, 137,438,953,472 octets per second, or about 1.100 terabits per second.