Conversion from 3 Tebibits per second to Bits per second

=

Invert

Formula to convert Tebibits per second (Tibit/s) to Bits per second (bit/s)

More information

Tebibits per second to Bits per second conversion table

Tebibits per second (Tibit/s)Bits per second (bit/s)
1 Tebibit per second1099511627776 bit/s
2 Tebibits per second2199023255552 bit/s
3 Tebibits per second3298534883328 bit/s
4 Tebibits per second4398046511104 bit/s
5 Tebibits per second5497558138880 bit/s
10 Tebibits per second10995116277760 bit/s
20 Tebibits per second21990232555520 bit/s
25 Tebibits per second27487790694400 bit/s
50 Tebibits per second54975581388800 bit/s
100 Tebibits per second109951162777600 bit/s

Data-transfer rate reference points

ReferenceTebibits per second (Tibit/s)Bits per second (bit/s)
A dial-up modem0.0000000509317 Tibit/s56000 bit/s
Typical home broadband0.0000909495 Tibit/s100000000 bit/s
Gigabit Ethernet0.000909495 Tibit/s1 × 109 bit/s
Streaming a 4K film0.0000227374 Tibit/s25000000 bit/s

Try our other unit converters

LengthMassTemperatureEnergyVolumeSpeedTimeDataPressureFrequencyData-transfer rateVolumetric flow rateAngleArea

Information about the Tebibit per second (Tibit/s)

The tebibit per second is a unit of data transfer rate equal to 1,099,511,627,776 bits per second, which is 1,024 gibibits per second. Its symbol is Tibit/s. It is the binary counterpart of the terabit per second, and the two differ by 10 per cent.

Ten per cent is the point at which the distinction becomes a matter of money rather than of pedantry. A supplier quoting a system at a hundred terabits per second and a customer measuring a hundred tebibits per second are not describing the same performance, and the difference is ten terabits — more than most organisations' entire external connectivity.

The rate belongs to the interior of very large machines. The aggregate memory bandwidth of a rack of accelerators, or the internal switching capacity of a large network chip, reaches this range, and both are built from power-of-two structures: memory channels of fixed binary width, switch ports in powers of two, buffers sized in binary. Expressing their totals with binary prefixes preserves the arithmetic that produced them.

In octets a tebibit per second is 137,438,953,472, or 128 gibioctets per second. That is more than any single storage device can supply and more than any external cable carries. It is a figure that describes something happening inside a cabinet, between chips connected by short traces on a board, where the physical distance is measured in centimetres.

Optical research also brushes this range. A laboratory demonstration carrying a petabit per second down one fibre is a thousand times higher, but individual wavelength channels and the electronics driving them work at tebibit-scale aggregates, and papers reporting them often state the binary figure because the underlying frame sizes are binary.

The habit of writing the lowercase i is worth keeping even where the reader is unlikely to check. A number written unambiguously can be converted correctly by anyone who reads it later; one written ambiguously cannot be repaired, and at ten per cent the ambiguity is no longer harmless.

One tebibit per second equals 1,024 gibibits per second, 137,438,953,472 octets per second, or about 1.100 terabits per second.


Information about the Bit per second (bit/s)

The bit per second is the fundamental unit of data transfer rate. Its symbol is bit/s, often written bps. It counts how many binary decisions a channel carries in one second, and every other unit of transmission speed is a multiple of it.

Because it is a rate, it has the form of a quantity divided by time, exactly like metres per second or litres per second. That makes the arithmetic straightforward: a link running at a given number of bits per second, multiplied by a duration in seconds, gives the total number of bits transferred, and dividing by eight converts that to octets.

The unit must be distinguished from the baud, which counts symbols per second rather than bits. Early modems transmitted one bit per symbol, so the two numbers were the same and the words were used interchangeably. Modern schemes encode several bits in each symbol — by varying phase and amplitude together — so a channel running at 3,000 baud may carry 33,600 bits per second. Only the bit rate describes how much information moves.

Claude Shannon established the theoretical ceiling in 1948. The capacity of a channel in bits per second depends on its bandwidth and on the ratio of signal to noise, and no coding scheme can exceed it. Every advance in modem and radio design since has been an attempt to approach that limit more closely, and modern systems come within a fraction of a decibel of it.

In practice the raw bit rate of a link is never the rate at which useful data arrives. Protocol headers, error-correcting codes, acknowledgements and retransmissions all consume capacity, and the usable fraction is typically 90 to 95 per cent on a wired link and considerably less on a shared wireless one.

Single bits per second are rarely quoted, because almost every channel is faster. The exceptions are deep-space communication, where a probe billions of kilometres away may return data at a few tens of bits per second, and certain low-power sensor networks that transmit a handful of bits at long intervals to preserve battery life.

One bit per second equals 0.125 octets per second, 0.001 kilobits per second, or about 0.0009766 kibibits per second.