Conversion from Zettabits per second to Gigabits per second

Information about the Zettabit per second (Zbit/s)

The zettabit per second is a unit of data transfer rate equal to a thousand exabits per second. Its symbol is Zbit/s. No system on Earth moves data at this rate, and none is planned; the unit exists because the metric system defines every prefix for every unit, whether or not the combination has yet been needed.

To see how far off it is, take the whole internet. Global traffic at present runs at roughly one exabit per second on average, so the entire planet's communications would have to grow a thousandfold to reach one zettabit per second. At the growth rates of the last two decades that would take somewhere between twenty and thirty years, which is precisely the sort of extrapolation that has been wrong in both directions before.

A zettabit per second is 125 exaoctets per second. Since global data storage manufacturing runs at a few hundred exaoctets a year, a link at this rate would transfer the world's entire annual production of new storage capacity in a couple of seconds. Nothing could be stored at the far end; the data would have to be processed and discarded as it arrived.

That last point is not as fanciful as it sounds. Several existing systems already discard almost everything they receive: particle detectors, radio telescope arrays and network monitoring systems all process far more than they keep, because keeping it is impossible and unnecessary. A zettabit-per-second link would be an extreme case of an architecture that already exists.

The physical obstacles are less absolute than they might appear. The theoretical capacity of a single optical fibre is far above what is used today, and the practical limits come from amplifier noise, non-linear effects and the electronics at each end rather than from the glass itself. Aggregating enough fibres would reach a zettabit per second; the difficulty is that nobody has a reason to.

For a converter, the unit matters because forecasts and capacity models are written in whatever unit keeps the numbers legible. A projection that reaches into the 2050s may reasonably state totals in zettabits per second, and a reader needs to be able to convert that into something familiar.

One zettabit per second equals 1,000 exabits per second, 125 exaoctets per second, or about 0.8470 zebibits per second.

Information about the Gigabit per second (Gbit/s)

The gigabit per second is a unit of data transfer rate equal to one thousand million bits per second. Its symbol is Gbit/s, often written Gbps. It names the standard of wired local networking and, increasingly, of domestic fibre connections.

Gigabit Ethernet was standardised in 1998 for optical fibre and in 1999 for ordinary twisted-pair copper, and the copper version is what made it universal. It runs a hundred metres over the same cabling that carried the hundred-megabit standard before it, which meant buildings could be upgraded by replacing equipment rather than wiring. That single property fixed the gigabit as the default connection for a generation.

In octets a gigabit per second is 125 megaoctets per second. That is roughly the speed of a good mechanical hard drive and well below a modern solid-state drive, which is why gigabit networking is no longer the bottleneck it once was: the network can now outrun the storage at one end or the other in many common setups.

Domestic fibre services advertise a gigabit routinely, and the figure has become a marketing threshold more than a technical one. Practically no household can saturate it — a gigabit is enough for around two hundred simultaneous high-definition video streams — and the benefit in daily use is not throughput but the absence of congestion, which keeps latency low and steady.

Above the gigabit the ladder continues in the same steps. Ten-gigabit Ethernet is standard between servers and switches in data centres; twenty-five, forty, hundred and four-hundred-gigabit links join racks, buildings and cities. Each is a multiple of the same unit, and each is still counted in bits per second because that is what the optics and the copper actually carry.

Wireless has followed. The later wireless local network standards quote peak rates above a gigabit per second, though those figures assume a single device, ideal conditions and the full width of the channel. Real wireless throughput in a normal home is typically a third to a half of the advertised peak, and the gap widens with every additional device.

One gigabit per second equals 1,000,000,000 bits per second, 125 megaoctets per second, or about 0.9313 gibibits per second.