Conversion from Centiares to Square nautical miles

Information about the Centiare (ca)

The centiare is a unit of area equal to one hundredth of an are, which makes it exactly one square metre. Its symbol is ca. It is the only unit in common use that is an exact duplicate of another under a different name, and the reason it exists at all is a matter of bookkeeping rather than of measurement.

When the French metric law of 1795 established the are as the decimal unit of land, it created a full ladder around it: the hectare above and the centiare below. Land registries then adopted a three-column format, recording every parcel as so many hectares, so many ares and so many centiares. The last column needed a name, and the square metre, though identical, did not fit the pattern.

That format is still in force. French, Belgian, Luxembourgish and Dutch land registers write parcel areas as three numbers in sequence, so 1 ha 25 a 30 ca means 12,530 square metres. The middle and last figures never exceed 99, which makes the notation self-checking: a value like 1 ha 130 a is malformed and signals a transcription error before anyone has to do arithmetic.

Reading it is a matter of place value. Each hectare is 10,000 square metres, each are is 100, and each centiare is one, so the three columns simply spell out a number in base one hundred. A notary's figure of 0 ha 04 a 62 ca is 462 square metres, and a surveyor's plan showing the same plot would print 462 m² without further comment.

Outside the land registry the centiare has no life. Nobody specifies a floor, a wall or a plot of ground in centiares when the square metre says the same thing with a symbol everyone recognises, and no branch of science or engineering has ever adopted it. It is a unit that exists to fill a column.

The one hazard is the symbol. In many documents ca is an abbreviation for the Latin circa, meaning approximately, so a figure that reads ca 400 could mean 400 centiares or about 400 of something else entirely. In land records the position of the number resolves it; in running text, converting to square metres removes the ambiguity for good.

One centiare equals exactly 1 square metre, 0.01 ares, or about 10.764 square feet.

Information about the Square nautical mile (sq nmi)

The square nautical mile is a unit of area equal to 3,429,904 square metres, or about 3.43 square kilometres. Its symbol is sq nmi. It is the area of a square one nautical mile on a side, the nautical mile being defined as exactly 1852 metres. It is the working unit of everything that happens at sea and is measured across a surface rather than along a line.

Its usefulness comes from the definition of the nautical mile itself. One nautical mile is very nearly one minute of latitude, so a square nautical mile is close to a one-minute cell on a chart. That makes it the natural grid square for anything plotted on a nautical chart, because the unit and the graticule agree without any conversion, and a navigator can read distance and area off the same scale.

Maritime law is written in nautical miles and therefore accounted in square ones. Under the international law of the sea, a coastal state has a territorial sea of twelve nautical miles, a contiguous zone of twenty-four and an exclusive economic zone reaching two hundred. The resulting areas are vast: a state with scattered island possessions can control several million square kilometres of ocean, and comparisons between such claims are usually made after converting these figures to metric.

Search and rescue planning depends on the unit directly. A search area is defined in square nautical miles, and the time to cover it follows from the search vessel's speed in knots and the sweep width of its sensors, both of which are already in nautical units. Keeping the whole calculation in one system is what allows a coordinator to estimate coverage without stopping to convert anything.

Fisheries science and naval operations use it the same way. Fish stock density is reported per square nautical mile, survey transects are spaced in nautical miles, exercise and restricted areas are drawn as blocks of them, and aviation control zones over water are described in the same terms because aircraft also navigate in knots.

For conversion, one square nautical mile is 3.43 square kilometres, 1.32 square statute miles, or about 848 acres. The ratio to the statute mile is not intuitive, since the nautical mile is only about 15 per cent longer but the square is a third larger, which is the usual consequence of squaring a length ratio.

One square nautical mile equals 3,429,904 square metres, about 3.43 square kilometres, about 1.32 square miles, or about 848 acres.