| Microliters (µL) | Teraliters (TL) |
|---|---|
| 1 Microliter | 1 × 10-18 TL |
| 2 Microliters | 2 × 10-18 TL |
| 3 Microliters | 3 × 10-18 TL |
| 4 Microliters | 4 × 10-18 TL |
| 5 Microliters | 5 × 10-18 TL |
| 10 Microliters | 1 × 10-17 TL |
| 20 Microliters | 2 × 10-17 TL |
| 25 Microliters | 2.5 × 10-17 TL |
| 50 Microliters | 5 × 10-17 TL |
| 100 Microliters | 1 × 10-16 TL |
| Reference | Microliters (µL) | Teraliters (TL) |
|---|---|---|
| A teaspoon | 5000 µL | 5 × 10-15 TL |
| A can of soft drink | 330000 µL | 3.3 × 10-13 TL |
| A wine bottle | 750000 µL | 7.5 × 10-13 TL |
| A bathtub | 150000000 µL | 1.5 × 10-10 TL |
| An Olympic swimming pool | 2.5 × 1012 µL | 0.0000025 TL |
The microlitre is a unit of volume equal to one millionth of a litre, written µL. It is exactly one cubic millimetre. It is the working unit of the molecular biology laboratory and of clinical haematology, and almost every quantity in modern biological science that is not a mass or a concentration is a number of microlitres.
Pipetting is what defines it in practice. Adjustable micropipettes are named after their maximum volume in microlitres, so a bench holds instruments of 2, 20, 200 and 1000, and a researcher's day consists largely of moving microlitres from one tube to another. A polymerase chain reaction is typically assembled in twenty to fifty microlitres, and a whole experiment may use less liquid than a teaspoon holds.
Blood counts are reported against it. White cells number between four thousand and eleven thousand per microlitre in a healthy adult, platelets between a hundred and fifty thousand and four hundred thousand, and red cells about five million. Those reference ranges are among the most widely used numbers in medicine, and all of them are counts within a cube one millimetre on a side.
Diagnostics has driven the volumes down. A modern blood glucose meter needs about half a microlitre of blood, which is why a finger-prick sample is enough where an earlier generation of instruments needed a syringe. Point-of-care analysers, lateral flow tests and microfluidic cartridges are all designed around the smallest sample a patient can be asked to give.
Analytical chemistry uses the same scale. Injection volumes in liquid chromatography run from one to twenty microlitres, gas chromatography uses one or less, and mass spectrometry samples are prepared in tens. Because the analytical signal depends on the amount injected, the accuracy of a microlitre-scale measurement sets the accuracy of the whole result.
The identity with the cubic millimetre is a genuine convenience. Haematology once reported cell counts per cubic millimetre and now reports them per microlitre, and the numbers did not change at all, because the two units are the same. That is a rare case of a unit change in medicine that required no re-education and produced no errors.
One microlitre equals 1 cubic millimetre, 0.001 millilitres, 0.000001 litres, or about 0.0000338 US fluid ounces.
The teralitre is a unit of volume equal to a thousand gigalitres, or 1,000,000,000,000 litres. Its symbol is TL. It is exactly one cubic kilometre, and that is how the quantity is almost always written, because at this scale what is being measured is no longer a container but a piece of the planet.
Lakes are the obvious application. Lake Baikal holds about 23,600 cubic kilometres of fresh water, more than any other lake on earth, and Lake Superior about 12,100. Those two figures alone amount to a fifth of the world's unfrozen surface fresh water, which is the kind of statement the unit exists to make.
Rivers are described by the volume they move rather than by what they hold. The Amazon discharges roughly 6600 cubic kilometres a year into the Atlantic, more than the next several rivers combined, and total human withdrawal of fresh water from all sources runs to about 4000 cubic kilometres a year. Setting those two numbers side by side in the same unit is one of the clearest ways to state the scale of water use.
Ice is measured here too, and the numbers are larger again. The Greenland ice sheet contains close to 2.9 million cubic kilometres, and in recent decades it has been losing a few hundred each year, a figure that converts directly into millimetres of sea level because the ocean's surface area is known. The Antarctic sheet is an order of magnitude larger still.
The ocean itself sets the ceiling. All the seawater on earth amounts to about 1.335 billion cubic kilometres, so a single teralitre is roughly one billionth of it. Below the ocean, the largest managed water bodies are engineered reservoirs, and even the biggest of those hold only a few tens of cubic kilometres.
In practice the name teralitre is rare and the cubic kilometre is standard. Hydrology, glaciology and climate science all use km³, and a figure given in teralitres is more likely to come from a water utility extending its own gigalitre scale upward than from a scientific source. The two are identical, so no conversion is needed, only recognition.
One teralitre equals 1,000,000,000,000 litres, 1,000,000,000 cubic metres, 1 cubic kilometre, or 1000 gigalitres.