Conversion from 10 Exabits per second to Kibibits per second

=

Invert

Formula to convert Exabits per second (Ebit/s) to Kibibits per second (Kibit/s)

More information

Exabits per second to Kibibits per second conversion table

Exabits per second (Ebit/s)Kibibits per second (Kibit/s)
1 Exabit per second976562500000000 Kibit/s
2 Exabits per second1.953125 × 1015 Kibit/s
3 Exabits per second2.9296875 × 1015 Kibit/s
4 Exabits per second3.90625 × 1015 Kibit/s
5 Exabits per second4.8828125 × 1015 Kibit/s
10 Exabits per second9.765625 × 1015 Kibit/s
20 Exabits per second1.953125 × 1016 Kibit/s
25 Exabits per second2.44140625 × 1016 Kibit/s
50 Exabits per second4.8828125 × 1016 Kibit/s
100 Exabits per second9.765625 × 1016 Kibit/s

Data-transfer rate reference points

ReferenceExabits per second (Ebit/s)Kibibits per second (Kibit/s)
A dial-up modem5.6 × 10-14 Ebit/s54.6875 Kibit/s
Typical home broadband1 × 10-10 Ebit/s97656.2 Kibit/s
Gigabit Ethernet0.000000001 Ebit/s976562 Kibit/s
Streaming a 4K film2.5 × 10-11 Ebit/s24414.1 Kibit/s

Try our other unit converters

LengthMassTemperatureEnergyVolumeSpeedTimeDataPressureFrequencyData-transfer rateVolumetric flow rateAngleArea

Information about the Exabit per second (Ebit/s)

The exabit per second is a unit of data transfer rate equal to a thousand petabits per second. Its symbol is Ebit/s. No link, no cable and no exchange point runs at this rate; the unit describes the internet as a whole, or a large part of it, at a single instant.

Global internet traffic can be expressed this way. Worldwide traffic of several hundred exaoctets a month works out to roughly one exabit per second on average, and peak hours run higher. That figure is the sum of every packet moving on every network on the planet, and it is the only quantity anyone routinely describes at this scale.

An exabit per second is 125 petaoctets per second. Nothing generates data at that rate in one place; the number is an aggregate of billions of separate flows, most of them tiny. A single video stream is a few megabits per second, so an exabit per second is on the order of a hundred million such streams running at once.

The composition of that traffic is dominated by video. Streaming services account for the largest share, followed by social platforms, software updates and cloud synchronisation. Ordinary web browsing and messaging, which people think of as the internet, are a small fraction of the total by volume even though they occupy most of the attention.

The unit also appears in projections of aggregate capacity. The total installed capacity of all submarine cables, if every wavelength on every fibre pair were lit and used simultaneously, is in the exabit-per-second range. Actual utilisation is far below that, because capacity is built ahead of demand and because routes must carry each other's traffic when a cable fails.

The prefix exa is a thousand to the sixth power. It was adopted in 1975, when nobody expected it to describe anything but astronomical quantities, and it now describes the working throughput of a communications system built by human beings. The interval between definition and everyday use was about forty years.

One exabit per second equals 1,000 petabits per second, 125 petaoctets per second, or about 0.8674 exbibits per second.


Information about the Kibibit per second (Kibit/s)

The kibibit per second is a unit of data transfer rate equal to 1,024 bits per second. Its symbol is Kibit/s. It is the binary counterpart of the kilobit per second, and it is the least used member of an already unusual family, because transfer rates are one of the few places in computing where the decimal convention has always been unambiguous.

Networking has counted in true thousands from the beginning. A modem rated at 56 kilobits per second meant fifty-six thousand, not fifty-seven thousand three hundred and forty-four. The reason is that a transmission rate is set by a clock, and clocks are specified in decimal frequencies: a link running at ten million symbols per second carries a decimal number of bits, not a power of two.

The binary prefixes exist for quantities, not for rates, because quantities of storage are organised in powers of two while time is not. There is no natural reason for a rate to be a power of two, and consequently no reason for a rate unit to need a binary prefix. Where one appears, it is almost always because a program divided a binary file size by a duration.

That is exactly where the kibibit per second does turn up. A tool that measures a transfer by counting kibioctets and dividing by seconds produces a rate in kibioctets per second, and multiplying by eight gives kibibits per second. The unit is a consequence of the arithmetic rather than a description of the channel.

For scale, a kibibit per second is 128 octets per second, and the difference from a kilobit per second is 2.4 per cent — smaller than the measurement error of almost any real throughput test. At this level the distinction is technically correct and practically invisible, which is a fair description of the whole binary prefix system at its lower end.

The unit is properly defined and a converter must handle it, because the IEC series applies to every unit without exception. Whether anyone writes it is a separate question from whether it means something definite, and it does.

One kibibit per second equals 1,024 bits per second, 128 octets per second, or 1.024 kilobits per second.