Conversion from Terabits per second to Pebibits per second

Information about the Terabit per second (Tbit/s)

The terabit per second is a unit of data transfer rate equal to a thousand gigabits per second. Its symbol is Tbit/s. It is the unit of the internet's backbone: the submarine cables, the exchange points and the long-haul optical links that carry traffic between continents.

A single modern transoceanic cable carries several hundred terabits per second. It achieves this not with one enormous channel but with wavelength division multiplexing, which sends dozens of separate colours of light down each fibre at once, and with several fibre pairs in the same cable. Each wavelength carries a few hundred gigabits, and the totals add up.

The historical comparison is worth stating plainly. The first transatlantic telephone cable, laid in 1956, carried thirty-six simultaneous voice calls. A cable laid in the 2020s carries hundreds of terabits per second, enough for hundreds of millions of simultaneous calls. That is a factor of roughly ten million in seventy years, and it was achieved almost entirely by changing what is sent down the glass rather than by laying more cable.

Internet exchange points, where networks meet and hand traffic to one another, publish their throughput in terabits per second. The largest in Europe and Asia peak in the tens of terabits, and those public graphs are among the most reliable measurements of how heavily the internet is being used at a given moment, because they count real traffic rather than capacity.

In octets, a terabit per second is 125 gigaoctets per second — the contents of a large laptop's disc moved every second, continuously. No single storage system can feed such a link; the traffic on these routes is the aggregate of millions of separate connections, each of them tiny by comparison.

Laboratory records go far higher, into petabits per second, using multi-core fibre and hundreds of wavelengths at once, though over short distances under controlled conditions. The gap between what is demonstrated in a laboratory and what is deployed under an ocean has historically been about a decade.

One terabit per second equals 1,000 gigabits per second, 125 gigaoctets per second, or about 0.9095 tebibits per second.

Information about the Pebibit per second (Pibit/s)

The pebibit per second is a unit of data transfer rate equal to 1,024 tebibits per second, which is two to the fiftieth power bits per second. Its symbol is Pibit/s. It is the binary counterpart of the petabit per second, and the two differ by 12.6 per cent.

No deployed system runs at this rate, and the unit therefore describes either an aggregate or a laboratory result. Optical transmission records set on single fibres reach a petabit per second, and the binary figure for the same experiment is 12.6 per cent lower — a difference that matters when comparing results between papers that use different conventions.

Where the unit is genuinely appropriate is in describing structures built from powers of two. The total switching capacity of a very large network fabric, built from ports and buffers that are all binary, is a binary quantity divided by time, and reporting it in decimal units discards the arithmetic that produced it. The same applies to the summed memory bandwidth of a machine whose channel count is a power of two.

In octets a pebibit per second is 140,737,488,355,328, which is 128 tebioctets per second. That is the storage of a thousand large consumer drives moved every second, and it exists only as a total across many thousands of parallel paths inside a single facility.

The size of the discrepancy at this level is the argument for the whole IEC series in miniature. What began as a harmless 2.4 per cent at the kibibit is now an eighth, and it compounds by 2.4 per cent at every further step. A convention that was acceptable for small numbers becomes untenable for large ones, and the point of the binary prefixes is to make the distinction visible before that happens.

For a converter, the arithmetic is unremarkable: multiply or divide by 1,024 the appropriate number of times, and by eight to reach octets. What matters is that the tool does not silently substitute the decimal unit when it sees a value it cannot label precisely.

One pebibit per second equals 1,024 tebibits per second, 140,737,488,355,328 octets per second, or about 1.126 petabits per second.