Conversion from Pebibits per second to Petaoctets per second

Information about the Pebibit per second (Pibit/s)

The pebibit per second is a unit of data transfer rate equal to 1,024 tebibits per second, which is two to the fiftieth power bits per second. Its symbol is Pibit/s. It is the binary counterpart of the petabit per second, and the two differ by 12.6 per cent.

No deployed system runs at this rate, and the unit therefore describes either an aggregate or a laboratory result. Optical transmission records set on single fibres reach a petabit per second, and the binary figure for the same experiment is 12.6 per cent lower — a difference that matters when comparing results between papers that use different conventions.

Where the unit is genuinely appropriate is in describing structures built from powers of two. The total switching capacity of a very large network fabric, built from ports and buffers that are all binary, is a binary quantity divided by time, and reporting it in decimal units discards the arithmetic that produced it. The same applies to the summed memory bandwidth of a machine whose channel count is a power of two.

In octets a pebibit per second is 140,737,488,355,328, which is 128 tebioctets per second. That is the storage of a thousand large consumer drives moved every second, and it exists only as a total across many thousands of parallel paths inside a single facility.

The size of the discrepancy at this level is the argument for the whole IEC series in miniature. What began as a harmless 2.4 per cent at the kibibit is now an eighth, and it compounds by 2.4 per cent at every further step. A convention that was acceptable for small numbers becomes untenable for large ones, and the point of the binary prefixes is to make the distinction visible before that happens.

For a converter, the arithmetic is unremarkable: multiply or divide by 1,024 the appropriate number of times, and by eight to reach octets. What matters is that the tool does not silently substitute the decimal unit when it sees a value it cannot label precisely.

One pebibit per second equals 1,024 tebibits per second, 140,737,488,355,328 octets per second, or about 1.126 petabits per second.

Information about the Petaoctet per second (Po/s)

The petaoctet per second is a unit of data transfer rate equal to a thousand teraoctets per second, or eight petabits per second. Its symbol is Po/s. It describes the total internal bandwidth of the largest computing machines rather than any single connection, and it exists as an aggregate rather than as a rate anything can sustain on its own.

The clearest case is the interconnect of an exascale supercomputer. Such a machine has tens of thousands of nodes, each linked to the network at hundreds of gigaoctets per second, and the sum across the whole fabric reaches petaoctets per second. That figure is the reason such machines can run a single calculation spread over the whole system rather than many small independent ones.

Memory bandwidth adds up the same way. A machine with ten thousand accelerators, each with several teraoctets per second of local memory bandwidth, has tens of petaoctets per second in total. Whether that total means anything depends entirely on the calculation: a problem that can be divided so each node works mostly on its own data can use it, and a problem that cannot, cannot.

Data centre networks reach this range too. The aggregate capacity of the switching fabric inside a very large facility, counting every link between every rack, is measured in petaoctets per second. The design goal is that any server can reach any other at close to full speed, which requires far more internal capacity than the facility's external connections.

For scale, a petaoctet per second would transfer the entire contents of a large national archive in a second, or fill every hard drive manufactured in a day within about a minute. No storage system can supply data at this rate, and none can absorb it; the number describes movement inside a machine, between memory and processors, where nothing is being stored at all.

The unit also serves in optical research, where a single fibre carrying a petabit per second is 125 teraoctets per second, and an experimental system aggregating several such fibres approaches the petaoctet. Those figures come from laboratories rather than from anything deployed.

One petaoctet per second equals 1,000 teraoctets per second, 8 petabits per second, or about 0.8882 pebioctets per second.