Conversion from Hectopascals to Kilopascals

Information about the Hectopascal (hPa)

The hectopascal is a unit of pressure equal to one hundred pascals. Its symbol is hPa. It is exactly one millibar, and that identity is the whole reason it exists: when meteorology moved to SI units in the 1980s, the hectopascal let every barometer, chart and forecast keep its numbers unchanged while changing the name on them.

Weather is its home and almost its only use. Standard atmospheric pressure at sea level is 1013.25 hectopascals, a settled high-pressure system reads 1020 to 1035, and a deep Atlantic depression can fall below 950. Isobars on a synoptic chart are drawn at four-hectopascal intervals, so the spacing of the lines is a direct picture of how hard the wind will blow.

Storm intensity is reported the same way. The central pressure of a tropical cyclone is the single most quoted measure of its strength, and the lowest sea-level pressure ever recorded was 870 hectopascals in Typhoon Tip in 1979. A drop of a few tens of hectopascals over a day is enough to turn ordinary weather into a severe event.

Altitude changes the reading steadily. Near sea level pressure falls by roughly one hectopascal for every eight metres of height gained, which is why a barometric altimeter works at all and why a barometer at home responds to being carried upstairs. That gradient weakens with altitude, so the relationship holds only in the lowest few kilometres.

Aviation depends on the unit for safety. Pilots set their altimeters to a local pressure figure given in hectopascals so that everyone in the same airspace measures height from the same datum, and above a defined transition altitude all aircraft switch to the standard setting of 1013 hectopascals so that vertical separation is preserved regardless of the weather. North American practice uses inches of mercury for the same purpose, and the two must never be confused.

For conversion, one hectopascal is one millibar exactly, 0.1 kilopascals, and about 0.0295 inches of mercury. The last of those is the figure to watch, since a reading of 30 inches of mercury and one of 1016 hectopascals describe the same afternoon.

One hectopascal equals 100 pascals, 1 millibar, 0.1 kilopascals, or about 0.0295 inches of mercury.

Information about the Kilopascal (kPa)

The kilopascal is a unit of pressure equal to one thousand pascals. Its symbol is kPa. It is a hundredth of a bar and ten hectopascals, and it is the coherent SI unit that engineering was meant to adopt when the pascal proved too small to write comfortably. Standard atmospheric pressure is 101.325 kilopascals.

Tyres are where most people meet it. Canada, Australia, New Zealand and much of Asia state recommended tyre pressures in kilopascals, so a car door placard reads 220 or 240 rather than 32 or 35 pounds per square inch. The two scales sit side by side on most modern gauges, and the conversion is close to seven kilopascals to the pound per square inch.

Civil engineering uses it for loads on ground and structure. The bearing capacity of a soil is quoted in kilopascals, a firm clay allowing perhaps 150 and a soft one much less, and wind loading on a facade is calculated in the same unit. Because a kilopascal is also a kilonewton per square metre, structural calculations move between force and pressure without a conversion factor.

Medicine uses it in one important place. Arterial blood gases are reported in kilopascals in Britain, Ireland and much of Europe, where a healthy oxygen partial pressure is eleven to thirteen, while the United States reports the same measurement in millimetres of mercury as eighty to a hundred. The two numbers describe identical blood, and a clinician reading a foreign chart must know which convention it follows.

Vacuum work counts downward in it. A rough vacuum is a few kilopascals absolute, a domestic vacuum cleaner pulls perhaps twenty kilopascals below atmospheric, and freeze-drying operates well under one. Stating vacuum as an absolute pressure in kilopascals avoids the ambiguity of describing it as a negative gauge pressure.

Its awkwardness is only rhetorical. A hundred kilopascals is exactly one bar and reads less neatly, which is why the bar has held on in Europe despite decades of official preference for the pascal. Where the kilopascal has won, as on Canadian and Australian tyre placards, it has done so because the number is printed rather than spoken.

One kilopascal equals 1000 pascals, 0.01 bar, 10 hectopascals, or about 0.145 pounds per square inch.