Conversion from 50 Exbioctets per second to Pebibits per second

Information about the Exbioctet per second (Eio/s)

The exbioctet per second is a unit of data transfer rate equal to 1,024 pebioctets per second, or two to the sixtieth power octets per second. Its symbol is Eio/s. It is the binary counterpart of the exaoctet per second, and the two differ by 15.3 per cent.

No machine, network or aggregate reaches this rate. An exbioctet per second is more than eight times the total instantaneous traffic of the entire internet, and it would move the world's whole stock of stored data in a matter of minutes. The unit describes a capacity with no source that could supply it and no destination that could take it in.

Two to the sixtieth is nevertheless a familiar number in computing, because it is the size of the address space a 64-bit machine can reach in octets divided by sixteen. The same power of two turns up in filesystem limits, in memory maps and in the design of every system built on that architecture, so the quantity is well known even though no rate approaches it.

The unit exists because the IEC series was defined completely. Every binary prefix pairs with every unit, exactly as every metric prefix does, so that a reader who has never seen Eio/s can decode it from the prefix alone. A system with gaps would need a table of permitted combinations, which is precisely what a rule-based system exists to avoid.

The difference from the decimal unit is worth restating at each level because it compounds. At the kibioctet it was 2.4 per cent, here it is more than an eighth, and at the yobioctet it will be more than a fifth. That growth is the reason the binary prefixes were created, and it is why the lowercase i has to be written even in figures nobody will check.

For a converter, the treatment is mechanical: six multiplications by 1,024 from octets, or the equivalent divisions coming down. The value of doing it correctly is not that anyone will use the result, but that a tool which handles every case the same way can be trusted on the cases that matter.

One exbioctet per second equals 1,024 pebioctets per second, 1,152,921,504,606,846,976 octets per second, or about 1.153 exaoctets per second.

Information about the Pebibit per second (Pibit/s)

The pebibit per second is a unit of data transfer rate equal to 1,024 tebibits per second, which is two to the fiftieth power bits per second. Its symbol is Pibit/s. It is the binary counterpart of the petabit per second, and the two differ by 12.6 per cent.

No deployed system runs at this rate, and the unit therefore describes either an aggregate or a laboratory result. Optical transmission records set on single fibres reach a petabit per second, and the binary figure for the same experiment is 12.6 per cent lower — a difference that matters when comparing results between papers that use different conventions.

Where the unit is genuinely appropriate is in describing structures built from powers of two. The total switching capacity of a very large network fabric, built from ports and buffers that are all binary, is a binary quantity divided by time, and reporting it in decimal units discards the arithmetic that produced it. The same applies to the summed memory bandwidth of a machine whose channel count is a power of two.

In octets a pebibit per second is 140,737,488,355,328, which is 128 tebioctets per second. That is the storage of a thousand large consumer drives moved every second, and it exists only as a total across many thousands of parallel paths inside a single facility.

The size of the discrepancy at this level is the argument for the whole IEC series in miniature. What began as a harmless 2.4 per cent at the kibibit is now an eighth, and it compounds by 2.4 per cent at every further step. A convention that was acceptable for small numbers becomes untenable for large ones, and the point of the binary prefixes is to make the distinction visible before that happens.

For a converter, the arithmetic is unremarkable: multiply or divide by 1,024 the appropriate number of times, and by eight to reach octets. What matters is that the tool does not silently substitute the decimal unit when it sees a value it cannot label precisely.

One pebibit per second equals 1,024 tebibits per second, 140,737,488,355,328 octets per second, or about 1.126 petabits per second.