Conversion from 50 Exabits per second to Gigabits per second

Information about the Exabit per second (Ebit/s)

The exabit per second is a unit of data transfer rate equal to a thousand petabits per second. Its symbol is Ebit/s. No link, no cable and no exchange point runs at this rate; the unit describes the internet as a whole, or a large part of it, at a single instant.

Global internet traffic can be expressed this way. Worldwide traffic of several hundred exaoctets a month works out to roughly one exabit per second on average, and peak hours run higher. That figure is the sum of every packet moving on every network on the planet, and it is the only quantity anyone routinely describes at this scale.

An exabit per second is 125 petaoctets per second. Nothing generates data at that rate in one place; the number is an aggregate of billions of separate flows, most of them tiny. A single video stream is a few megabits per second, so an exabit per second is on the order of a hundred million such streams running at once.

The composition of that traffic is dominated by video. Streaming services account for the largest share, followed by social platforms, software updates and cloud synchronisation. Ordinary web browsing and messaging, which people think of as the internet, are a small fraction of the total by volume even though they occupy most of the attention.

The unit also appears in projections of aggregate capacity. The total installed capacity of all submarine cables, if every wavelength on every fibre pair were lit and used simultaneously, is in the exabit-per-second range. Actual utilisation is far below that, because capacity is built ahead of demand and because routes must carry each other's traffic when a cable fails.

The prefix exa is a thousand to the sixth power. It was adopted in 1975, when nobody expected it to describe anything but astronomical quantities, and it now describes the working throughput of a communications system built by human beings. The interval between definition and everyday use was about forty years.

One exabit per second equals 1,000 petabits per second, 125 petaoctets per second, or about 0.8674 exbibits per second.

Information about the Gigabit per second (Gbit/s)

The gigabit per second is a unit of data transfer rate equal to one thousand million bits per second. Its symbol is Gbit/s, often written Gbps. It names the standard of wired local networking and, increasingly, of domestic fibre connections.

Gigabit Ethernet was standardised in 1998 for optical fibre and in 1999 for ordinary twisted-pair copper, and the copper version is what made it universal. It runs a hundred metres over the same cabling that carried the hundred-megabit standard before it, which meant buildings could be upgraded by replacing equipment rather than wiring. That single property fixed the gigabit as the default connection for a generation.

In octets a gigabit per second is 125 megaoctets per second. That is roughly the speed of a good mechanical hard drive and well below a modern solid-state drive, which is why gigabit networking is no longer the bottleneck it once was: the network can now outrun the storage at one end or the other in many common setups.

Domestic fibre services advertise a gigabit routinely, and the figure has become a marketing threshold more than a technical one. Practically no household can saturate it — a gigabit is enough for around two hundred simultaneous high-definition video streams — and the benefit in daily use is not throughput but the absence of congestion, which keeps latency low and steady.

Above the gigabit the ladder continues in the same steps. Ten-gigabit Ethernet is standard between servers and switches in data centres; twenty-five, forty, hundred and four-hundred-gigabit links join racks, buildings and cities. Each is a multiple of the same unit, and each is still counted in bits per second because that is what the optics and the copper actually carry.

Wireless has followed. The later wireless local network standards quote peak rates above a gigabit per second, though those figures assume a single device, ideal conditions and the full width of the channel. Real wireless throughput in a normal home is typically a third to a half of the advertised peak, and the gap widens with every additional device.

One gigabit per second equals 1,000,000,000 bits per second, 125 megaoctets per second, or about 0.9313 gibibits per second.