| Nautical leagues (nlea) | Millimeters (mm) |
|---|---|
| 1 Nautical league | 5556000 mm |
| 2 Nautical leagues | 11112000 mm |
| 3 Nautical leagues | 16668000 mm |
| 4 Nautical leagues | 22224000 mm |
| 5 Nautical leagues | 27780000 mm |
| 10 Nautical leagues | 55560000 mm |
| 20 Nautical leagues | 111120000 mm |
| 25 Nautical leagues | 138900000 mm |
| 50 Nautical leagues | 277800000 mm |
| 100 Nautical leagues | 555600000 mm |
| Reference | Nautical leagues (nlea) | Millimeters (mm) |
|---|---|---|
| A sheet of A4 paper (long side) | 0.0000534557 nlea | 297 mm |
| Average adult human height | 0.000305976 nlea | 1700 mm |
| A football pitch (length) | 0.0188985 nlea | 105000 mm |
| A marathon | 7.59449 nlea | 42195000 mm |
| Height of Mount Everest | 1.59269 nlea | 8849000 mm |
The nautical league is a unit of length equal to three nautical miles, or exactly 5556 metres. It is longer than the land league by about 728 metres, since it is built from the nautical mile of 1852 metres rather than the statute mile.
The unit belonged to an era when it was the practical measure of coastal jurisdiction. The cannon shot rule, articulated in the seventeenth and eighteenth centuries, held that a state's authority extended as far as it could defend from shore, conventionally taken as three nautical miles. That distance became the standard territorial sea limit and was expressed as one marine league. Many older treaties and statutes define maritime boundaries in leagues for this reason.
The three-mile limit held for centuries before eroding through the twentieth. States progressively claimed wider waters, and the United Nations Convention on the Law of the Sea settled the matter in 1982 by establishing a twelve nautical mile territorial sea and a two hundred mile exclusive economic zone. Both figures are stated in nautical miles rather than leagues, and the older unit fell out of legal use.
Charts and pilot books from the age of sail used the league routinely for describing offshore distances and the visibility of landmarks. Reading those sources accurately requires knowing which league is meant, since the same word could refer to a land league, a marine league or a Spanish or Portuguese variant, and the differences are large enough to matter when reconstructing a historical position.
Today the unit has no navigational role. Charts are marked in nautical miles, and distances at sea are quoted the same way. The nautical league appears only in historical and legal texts.
The unit also underlies a familiar figure in visibility calculations. From a height of about three metres above sea level, the horizon lies roughly one nautical league away, which is why the three-mile limit corresponded loosely to what a lookout could see as well as to what a gun could reach.
One nautical league equals 3 nautical miles, 5556 metres, 5.556 kilometres, or about 3.452 statute miles.
The millimetre is one thousandth of a metre, written mm. It is the smallest division marked on most rulers and tape measures, which makes it the practical floor of everyday measurement in countries using the metric system.
Technical drawing has settled on the millimetre almost universally. Mechanical engineering drawings state dimensions in millimetres by default, usually without writing the unit at all, because the convention is understood. This avoids the decimal points that centimetres would introduce and the large numbers that micrometres would require. A component 45.5 mm long is easier to read and harder to misinterpret than one 4.55 cm or 45500 µm long.
Meteorology uses the millimetre for rainfall. A reading of 25 mm means that rain would stand 25 millimetres deep on a flat surface that did not drain, which corresponds to 25 litres per square metre. Snowfall is usually reported as depth in centimetres and separately as liquid water equivalent in millimetres.
Medicine relies on the unit for tumour dimensions, wound measurement and the size of anatomical structures on imaging. Ophthalmic prescriptions specify pupillary distance in millimetres. Blood pressure retains the older unit of millimetres of mercury, a pressure measurement whose name preserves the height of a mercury column.
Paper, sheet metal and glass are specified by thickness in millimetres. A standard sheet of office paper is about 0.1 mm thick. Domestic window glass is commonly 4 mm. Firearm and ammunition calibres are frequently given in millimetres, as in 9 mm.
Fastener sizes follow the unit closely. Metric bolts and screws are designated by their nominal diameter in millimetres, so an M8 bolt has an eight-millimetre thread. Spanner and socket sizes are marked the same way, measuring across the flats of the fastener head. This is why a metric toolkit contains an unbroken run of sizes rather than the fractional inch steps of an imperial set.
Medicine measures pressure with it as well as distance. Blood pressure is reported in millimetres of mercury, the height of a mercury column the pressure would support, so a healthy reading of 120 over 80 refers to two lengths rather than to any force directly. The convention dates from the mercury manometer and has survived every instrument that replaced it, because the numbers are familiar to every clinician alive. The same unit measures intraocular pressure in the eye, central venous pressure and the partial pressures of gases in blood, and it appears in vacuum work as the torr, which is one millimetre of mercury under another name.
One millimetre equals 1000 micrometres, 0.1 centimetres, or 0.001 metres. It is roughly 0.03937 inches, so 25.4 millimetres make exactly one inch.