Conversion from 20 Nanopascals to Micropascals

Information about the Nanopascal (nPa)

The nanopascal is a unit of pressure equal to one billionth of a pascal. Its symbol is nPa. It marks the far end of the pressure scale, the region where the idea of pressure as a push on a surface stops being useful and becomes a statement about how few particles are present.

The clearest home for the unit is extreme high vacuum. Ordinary laboratory vacuum reaches millipascals; ultra-high vacuum, used for surface physics and for the beam pipes of particle accelerators, reaches micropascals. Below that lies extreme high vacuum at nanopascals and lower, and reaching it takes a sealed chamber, hours of baking at two hundred degrees to drive gas out of the metal itself, and pumps that trap molecules rather than push them.

At those pressures a chamber is not empty. A nanopascal still contains something like a quarter of a million molecules per cubic centimetre, which sounds like a great many until you compare it with the twenty-five billion billion in the same volume of room air. What matters is not the count but the mean free path: a molecule now travels thousands of kilometres before striking another, so it hits the walls long before it meets a neighbour.

That is exactly the point. Surface science needs a sample to stay clean for the length of an experiment, and at ordinary pressures a fresh surface is covered by a layer of adsorbed gas in about a nanosecond. At a nanopascal the same surface stays clean for days. The vacuum is not there to remove air but to buy time.

Space provides the natural comparison. Low Earth orbit is around a micropascal, still dense enough that the atmosphere drags on satellites and eventually pulls them down. Interplanetary space is nanopascals. Interstellar space is far lower still, roughly a femtopascal, which no terrestrial pump has ever matched — the best laboratory vacuums are still denser than the space between the stars.

Radiation pressure lands in similar territory. Sunlight falling on a perfectly absorbing surface at Earth's distance exerts about 4.5 micropascals, and at the distance of the outer planets it falls to nanopascals. Solar sails work with these numbers, which is why they must be enormous and light to gather a usable force.

One nanopascal equals 0.000000001 pascals, 0.001 micropascals, 1,000 picopascals, or about 0.000000000000145 pounds per square inch.

Information about the Micropascal (µPa)

The micropascal is a unit of pressure equal to one millionth of a pascal. Its symbol is µPa. It is one of the smallest pressure units in practical use, and it owes its place to a single number: 20 micropascals, the reference pressure against which every sound level in air is measured.

That figure is the threshold of hearing — roughly the quietest sound a healthy young ear can detect at a frequency of about 1,000 hertz. When acousticians defined the decibel scale for airborne sound they needed a fixed pressure to compare against, and they chose that threshold. Zero decibels means a sound pressure of 20 micropascals; every decibel figure quoted for a road, a machine or a concert is a ratio to that number.

The scale that follows is steep. Twenty decibels is ten times the reference pressure, 200 micropascals. Sixty decibels, ordinary conversation, is a thousand times it, or 20 millipascals. A hundred and twenty decibels, the threshold of pain, is a million times it: 20 pascals. The ear covers a range of a million to one in pressure, and the micropascal sits at the bottom of it.

Underwater acoustics uses the same unit but a different reference. Sound in water is referred to 1 micropascal rather than 20, because the threshold of human hearing is meaningless in the sea. That difference matters enormously: a level quoted in decibels underwater is not comparable to one in air, and the gap between the two conventions is about 26 decibels before any other correction. Sonar figures, whale-song measurements and shipping-noise studies all carry the re 1 µPa qualifier for that reason.

Outside acoustics the micropascal appears in vacuum science. A good high vacuum is around 100 micropascals, and ultra-high vacuum, the regime used for surface physics and particle accelerators, runs from a few micropascals down to nanopascals. Pumping a chamber to that level takes hours of baking to drive adsorbed gas off the walls.

The unit also shows up in radiation pressure and in the very small pressure differences that laboratory instruments resolve. Anything measured in micropascals is a measurement rather than a force anyone would feel, which is exactly what makes the reference-level convention so useful.

One micropascal equals 0.000001 pascals, 0.001 millipascals, 1,000 nanopascals, or about 0.000000000145 pounds per square inch.