| Decapascals (daPa) | Millipascals (mPa) |
|---|---|
| 1 Decapascal | 10000 mPa |
| 2 Decapascals | 20000 mPa |
| 3 Decapascals | 30000 mPa |
| 4 Decapascals | 40000 mPa |
| 5 Decapascals | 50000 mPa |
| 10 Decapascals | 100000 mPa |
| 20 Decapascals | 200000 mPa |
| 25 Decapascals | 250000 mPa |
| 50 Decapascals | 500000 mPa |
| 100 Decapascals | 1000000 mPa |
| Reference | Decapascals (daPa) | Millipascals (mPa) |
|---|---|---|
| Atmospheric pressure at sea level | 10132.5 daPa | 101325000 mPa |
| Healthy blood pressure (120 mmHg) | 1600 daPa | 16000000 mPa |
| A car tyre | 22000 daPa | 220000000 mPa |
| A racing bicycle tyre | 60000 daPa | 600000000 mPa |
The decapascal is a unit of pressure equal to ten pascals. Its symbol is daPa. Deca is the least used prefix in the metric system almost everywhere, but the decapascal is an exception, because one clinical discipline adopted it and has kept it: audiology measures the pressure inside the middle ear in decapascals.
Tympanometry is the test in question. A probe seals the ear canal and varies the air pressure in it while measuring how much sound the eardrum reflects, and the resulting curve is plotted against pressure in decapascals. The sweep runs from about plus 200 to minus 400, and the position of the peak shows the pressure at which the eardrum moves most freely, which is normally the pressure of the middle ear itself.
That single graph carries a great deal of clinical information. A peak near zero means the middle ear is at the same pressure as the room, which is the healthy state. A peak displaced towards minus 200 or beyond suggests the Eustachian tube is not equalising properly, and a flat curve with no peak at all suggests fluid behind the eardrum. Each of those readings is a position on a decapascal scale.
The unit was chosen for the same reason the hectopascal was chosen in meteorology. Middle-ear pressure had long been recorded in millimetres of water, and one millimetre of water is 0.98 decapascals, so switching to the metric unit left every clinical number and every published reference range almost unchanged. A change of unit that shifts the figures by two per cent is one that practitioners will actually accept.
Outside audiology the decapascal is essentially unused. Ventilation and building airtightness work at similar pressures, an airtightness test being run at fifty pascals, but those figures are written in pascals, and everything above them moves to hectopascals or kilopascals. The gap between one and a hundred pascals is otherwise unclaimed.
For scale, ten pascals is the pressure a light breeze exerts on a wall, or the difference between the two ends of a well-sealed corridor when a door opens. It is also roughly the pressure change from riding a lift up one floor, which is why ears sometimes need clearing in a tall building.
One decapascal equals 10 pascals, 0.1 hectopascals, about 1.02 millimetres of water, or about 0.00145 pounds per square inch.
The millipascal is a unit of pressure equal to one thousandth of a pascal. Its symbol is mPa. The pascal is already a very small unit — it is the pressure of a sheet of paper lying on a table — so a thousandth of one is smaller than almost any pressure a person encounters. It survives because two fields genuinely work at that scale: acoustics and viscosity.
Sound is a pressure wave, and the pressures involved are tiny. Ordinary conversation at a metre carries a sound pressure of about 20 millipascals. A whisper is nearer 2, and the threshold of hearing, the quietest sound a healthy young ear can detect, is 0.02 millipascals, which is 20 micropascals. A loud rock concert reaches a few pascals. The entire useful range of human hearing therefore lives between a hundredth of a millipascal and a few thousand of them.
That is why sound is reported in decibels rather than in pressure units. A range spanning a factor of a million is unwieldy in linear numbers, so acoustics takes the logarithm and anchors it at the threshold of hearing. But the decibel is not a unit of pressure at all: behind every decibel figure is a pressure in pascals or millipascals, and instrument calibration is done in those real units.
The second use is stranger, because it is not a pressure at all. Dynamic viscosity is measured in pascal seconds, and almost every liquid people care about lands in the millipascal second range. Water at room temperature is 1 mPa·s exactly enough for practical purposes. That happens to equal one centipoise in the older CGS system, so the switch to SI left every viscosity table numerically unchanged, which is why the millipascal second took hold where the millipascal alone did not.
With that scale in hand, the numbers become legible. Petrol is about 0.6 mPa·s, olive oil about 80, honey several thousand, and glycerol around 1,400. Blood plasma is about 1.3, and whole blood nearer 4, which is one reason blood flow is harder to model than water flow.
For pressure itself, outside acoustics, the millipascal appears in vacuum work and in the gentlest of laboratory measurements — the pressure differences that drive slow gas flow, or the residual pressure in a chamber that has been pumped down hard. In those settings the alternative units are the micropascal below and the pascal above.
One millipascal equals 0.001 pascals, one thousand micropascals, 0.00001 millibars, or about 0.000000145 pounds per square inch.