Conversion from Millipascals to Kilopascals

Information about the Millipascal (mPa)

The millipascal is a unit of pressure equal to one thousandth of a pascal. Its symbol is mPa. The pascal is already a very small unit — it is the pressure of a sheet of paper lying on a table — so a thousandth of one is smaller than almost any pressure a person encounters. It survives because two fields genuinely work at that scale: acoustics and viscosity.

Sound is a pressure wave, and the pressures involved are tiny. Ordinary conversation at a metre carries a sound pressure of about 20 millipascals. A whisper is nearer 2, and the threshold of hearing, the quietest sound a healthy young ear can detect, is 0.02 millipascals, which is 20 micropascals. A loud rock concert reaches a few pascals. The entire useful range of human hearing therefore lives between a hundredth of a millipascal and a few thousand of them.

That is why sound is reported in decibels rather than in pressure units. A range spanning a factor of a million is unwieldy in linear numbers, so acoustics takes the logarithm and anchors it at the threshold of hearing. But the decibel is not a unit of pressure at all: behind every decibel figure is a pressure in pascals or millipascals, and instrument calibration is done in those real units.

The second use is stranger, because it is not a pressure at all. Dynamic viscosity is measured in pascal seconds, and almost every liquid people care about lands in the millipascal second range. Water at room temperature is 1 mPa·s exactly enough for practical purposes. That happens to equal one centipoise in the older CGS system, so the switch to SI left every viscosity table numerically unchanged, which is why the millipascal second took hold where the millipascal alone did not.

With that scale in hand, the numbers become legible. Petrol is about 0.6 mPa·s, olive oil about 80, honey several thousand, and glycerol around 1,400. Blood plasma is about 1.3, and whole blood nearer 4, which is one reason blood flow is harder to model than water flow.

For pressure itself, outside acoustics, the millipascal appears in vacuum work and in the gentlest of laboratory measurements — the pressure differences that drive slow gas flow, or the residual pressure in a chamber that has been pumped down hard. In those settings the alternative units are the micropascal below and the pascal above.

One millipascal equals 0.001 pascals, one thousand micropascals, 0.00001 millibars, or about 0.000000145 pounds per square inch.

Information about the Kilopascal (kPa)

The kilopascal is a unit of pressure equal to one thousand pascals. Its symbol is kPa. It is a hundredth of a bar and ten hectopascals, and it is the coherent SI unit that engineering was meant to adopt when the pascal proved too small to write comfortably. Standard atmospheric pressure is 101.325 kilopascals.

Tyres are where most people meet it. Canada, Australia, New Zealand and much of Asia state recommended tyre pressures in kilopascals, so a car door placard reads 220 or 240 rather than 32 or 35 pounds per square inch. The two scales sit side by side on most modern gauges, and the conversion is close to seven kilopascals to the pound per square inch.

Civil engineering uses it for loads on ground and structure. The bearing capacity of a soil is quoted in kilopascals, a firm clay allowing perhaps 150 and a soft one much less, and wind loading on a facade is calculated in the same unit. Because a kilopascal is also a kilonewton per square metre, structural calculations move between force and pressure without a conversion factor.

Medicine uses it in one important place. Arterial blood gases are reported in kilopascals in Britain, Ireland and much of Europe, where a healthy oxygen partial pressure is eleven to thirteen, while the United States reports the same measurement in millimetres of mercury as eighty to a hundred. The two numbers describe identical blood, and a clinician reading a foreign chart must know which convention it follows.

Vacuum work counts downward in it. A rough vacuum is a few kilopascals absolute, a domestic vacuum cleaner pulls perhaps twenty kilopascals below atmospheric, and freeze-drying operates well under one. Stating vacuum as an absolute pressure in kilopascals avoids the ambiguity of describing it as a negative gauge pressure.

Its awkwardness is only rhetorical. A hundred kilopascals is exactly one bar and reads less neatly, which is why the bar has held on in Europe despite decades of official preference for the pascal. Where the kilopascal has won, as on Canadian and Australian tyre placards, it has done so because the number is printed rather than spoken.

One kilopascal equals 1000 pascals, 0.01 bar, 10 hectopascals, or about 0.145 pounds per square inch.