Conversion from 5 Micropascals to Decapascals

Information about the Micropascal (µPa)

The micropascal is a unit of pressure equal to one millionth of a pascal. Its symbol is µPa. It is one of the smallest pressure units in practical use, and it owes its place to a single number: 20 micropascals, the reference pressure against which every sound level in air is measured.

That figure is the threshold of hearing — roughly the quietest sound a healthy young ear can detect at a frequency of about 1,000 hertz. When acousticians defined the decibel scale for airborne sound they needed a fixed pressure to compare against, and they chose that threshold. Zero decibels means a sound pressure of 20 micropascals; every decibel figure quoted for a road, a machine or a concert is a ratio to that number.

The scale that follows is steep. Twenty decibels is ten times the reference pressure, 200 micropascals. Sixty decibels, ordinary conversation, is a thousand times it, or 20 millipascals. A hundred and twenty decibels, the threshold of pain, is a million times it: 20 pascals. The ear covers a range of a million to one in pressure, and the micropascal sits at the bottom of it.

Underwater acoustics uses the same unit but a different reference. Sound in water is referred to 1 micropascal rather than 20, because the threshold of human hearing is meaningless in the sea. That difference matters enormously: a level quoted in decibels underwater is not comparable to one in air, and the gap between the two conventions is about 26 decibels before any other correction. Sonar figures, whale-song measurements and shipping-noise studies all carry the re 1 µPa qualifier for that reason.

Outside acoustics the micropascal appears in vacuum science. A good high vacuum is around 100 micropascals, and ultra-high vacuum, the regime used for surface physics and particle accelerators, runs from a few micropascals down to nanopascals. Pumping a chamber to that level takes hours of baking to drive adsorbed gas off the walls.

The unit also shows up in radiation pressure and in the very small pressure differences that laboratory instruments resolve. Anything measured in micropascals is a measurement rather than a force anyone would feel, which is exactly what makes the reference-level convention so useful.

One micropascal equals 0.000001 pascals, 0.001 millipascals, 1,000 nanopascals, or about 0.000000000145 pounds per square inch.

Information about the Decapascal (daPa)

The decapascal is a unit of pressure equal to ten pascals. Its symbol is daPa. Deca is the least used prefix in the metric system almost everywhere, but the decapascal is an exception, because one clinical discipline adopted it and has kept it: audiology measures the pressure inside the middle ear in decapascals.

Tympanometry is the test in question. A probe seals the ear canal and varies the air pressure in it while measuring how much sound the eardrum reflects, and the resulting curve is plotted against pressure in decapascals. The sweep runs from about plus 200 to minus 400, and the position of the peak shows the pressure at which the eardrum moves most freely, which is normally the pressure of the middle ear itself.

That single graph carries a great deal of clinical information. A peak near zero means the middle ear is at the same pressure as the room, which is the healthy state. A peak displaced towards minus 200 or beyond suggests the Eustachian tube is not equalising properly, and a flat curve with no peak at all suggests fluid behind the eardrum. Each of those readings is a position on a decapascal scale.

The unit was chosen for the same reason the hectopascal was chosen in meteorology. Middle-ear pressure had long been recorded in millimetres of water, and one millimetre of water is 0.98 decapascals, so switching to the metric unit left every clinical number and every published reference range almost unchanged. A change of unit that shifts the figures by two per cent is one that practitioners will actually accept.

Outside audiology the decapascal is essentially unused. Ventilation and building airtightness work at similar pressures, an airtightness test being run at fifty pascals, but those figures are written in pascals, and everything above them moves to hectopascals or kilopascals. The gap between one and a hundred pascals is otherwise unclaimed.

For scale, ten pascals is the pressure a light breeze exerts on a wall, or the difference between the two ends of a well-sealed corridor when a door opens. It is also roughly the pressure change from riding a lift up one floor, which is why ears sometimes need clearing in a tall building.

One decapascal equals 10 pascals, 0.1 hectopascals, about 1.02 millimetres of water, or about 0.00145 pounds per square inch.