Conversion from 25 Tebioctets per second to Mebibits per second

Information about the Tebioctet per second (Tio/s)

The tebioctet per second is a unit of data transfer rate equal to 1,024 gibioctets per second, or two to the fortieth power octets per second. Its symbol is Tio/s. It is the binary counterpart of the teraoctet per second, and the two differ by 10 per cent.

Nothing outside a large machine moves data this quickly. The rate describes the memory bandwidth of an accelerator with stacked memory, the internal fabric of a high-end processor package, or the aggregate throughput of a parallel filesystem spread across thousands of drives. All of these are built from binary structures, and their totals are binary quantities divided by time.

High-performance computing is where the unit is written most often. A supercomputer's storage system is specified by how many tebioctets per second it can deliver to the compute nodes, because that number determines how quickly a simulation can save its state and resume. A machine that computes quickly but writes slowly spends its time waiting.

The ten per cent difference from the decimal unit is significant in that context. A filesystem procured to deliver 10 teraoctets per second and one delivering 10 tebioctets per second differ by a whole teraoctet per second, which in a facility of that size represents a substantial fraction of the hardware budget.

In bits a tebioctet per second is 8 tebibits per second, and in decimal terms about 1.1 teraoctets per second. Expressing the same rate four different ways is routine at this level, because the storage industry, the memory industry, the network industry and the standards bodies each prefer a different one.

For everyday comparison, a tebioctet per second would fill a large consumer hard drive in about twenty seconds. No external interface carries this; the figure describes movement between components inside a single system, where the wires are short and there are very many of them running in parallel.

Graphics processors have brought the rate within reach of a single component. A stack of high-bandwidth memory bonded directly to the processor die delivers well over a tebioctet per second to the chip that uses it, and a card carrying several such stacks passes a few. That bandwidth, rather than raw arithmetic speed, is what limits the training of large models: the arithmetic units sit idle unless the memory can keep them fed. The same reasoning explains why supercomputer designers spend as much effort on the paths between memory and processor as on the processors themselves, and why the rate is quoted in binary units when the memory it describes is addressed in powers of two.

One tebioctet per second equals 1,024 gibioctets per second, 1,099,511,627,776 octets per second, or about 1.100 teraoctets per second.

Information about the Mebibit per second (Mibit/s)

The mebibit per second is a unit of data transfer rate equal to 1,048,576 bits per second. Its symbol is Mibit/s. It is the binary counterpart of the megabit per second, and the two differ by 4.9 per cent — small, but large enough to change a headline figure.

That five per cent is where the unit starts to matter. A connection advertised at 100 megabits per second and a connection at 100 mebibits per second differ by about five megabits, which is a whole high-definition video stream. In a specification, a contract or a benchmark report, quoting one and delivering the other is a real discrepancy rather than a rounding difference.

In practice the confusion is rare in networking, because network equipment is always specified in decimal. What produces mebibit figures is measurement software: a tool that counts a transfer in mebioctets and divides by elapsed seconds is reporting a binary rate, and multiplying by eight makes it mebibits per second. A person comparing that reading with an advertised rate must convert twice, once for the base and once for the factor of eight.

Where a genuine binary rate does arise is inside a machine. A memory bus transfers a fixed number of bits per clock cycle, and the width is a power of two — sixty-four bits at a time, for instance — so the quantity moved per cycle is binary even though the clock frequency is not. Rates derived from such a structure are naturally expressed with binary prefixes.

For scale, a mebibit per second is 131,072 octets per second, or about 128 kibioctets per second. That is roughly a photograph every two seconds, or a plain-text novel every four. It is a rate at which the modern web is slow but usable, which puts it in the range that mobile networks fall to when congested.

The correct symbol has the lowercase i, and its presence is the only reliable way to tell the two conventions apart. A document writing Mbit/s in a context where the underlying figure came from a binary computation has misstated its own measurement by five per cent.

One mebibit per second equals 1,048,576 bits per second, 131,072 octets per second, or about 1.049 megabits per second.