Conversion from 20 Decapascals to Pascals

Information about the Decapascal (daPa)

The decapascal is a unit of pressure equal to ten pascals. Its symbol is daPa. Deca is the least used prefix in the metric system almost everywhere, but the decapascal is an exception, because one clinical discipline adopted it and has kept it: audiology measures the pressure inside the middle ear in decapascals.

Tympanometry is the test in question. A probe seals the ear canal and varies the air pressure in it while measuring how much sound the eardrum reflects, and the resulting curve is plotted against pressure in decapascals. The sweep runs from about plus 200 to minus 400, and the position of the peak shows the pressure at which the eardrum moves most freely, which is normally the pressure of the middle ear itself.

That single graph carries a great deal of clinical information. A peak near zero means the middle ear is at the same pressure as the room, which is the healthy state. A peak displaced towards minus 200 or beyond suggests the Eustachian tube is not equalising properly, and a flat curve with no peak at all suggests fluid behind the eardrum. Each of those readings is a position on a decapascal scale.

The unit was chosen for the same reason the hectopascal was chosen in meteorology. Middle-ear pressure had long been recorded in millimetres of water, and one millimetre of water is 0.98 decapascals, so switching to the metric unit left every clinical number and every published reference range almost unchanged. A change of unit that shifts the figures by two per cent is one that practitioners will actually accept.

Outside audiology the decapascal is essentially unused. Ventilation and building airtightness work at similar pressures, an airtightness test being run at fifty pascals, but those figures are written in pascals, and everything above them moves to hectopascals or kilopascals. The gap between one and a hundred pascals is otherwise unclaimed.

For scale, ten pascals is the pressure a light breeze exerts on a wall, or the difference between the two ends of a well-sealed corridor when a door opens. It is also roughly the pressure change from riding a lift up one floor, which is why ears sometimes need clearing in a tall building.

One decapascal equals 10 pascals, 0.1 hectopascals, about 1.02 millimetres of water, or about 0.00145 pounds per square inch.

Information about the Pascal (Pa)

The pascal is the SI unit of pressure, written Pa. It is defined as one newton of force spread over one square metre, and it is named after Blaise Pascal, whose experiments with barometers in the 1640s established that air has weight and that its pressure falls with altitude. The General Conference on Weights and Measures adopted the name in 1971.

It is a remarkably small unit. Atmospheric pressure at sea level is 101,325 pascals, so the pressure everyone lives under is a six-figure number, and almost every practical use of the unit therefore carries a prefix. That awkwardness is not a design fault but a consequence of coherence: the newton and the square metre were fixed first, and the pascal is whatever falls out of dividing one by the other.

Acoustics is the field where bare pascals are natural. The reference pressure for the decibel scale is twenty micropascals, taken as the quietest sound a healthy young ear can detect, and ordinary conversation is around 0.02 pascals of sound pressure. The threshold of pain sits near 63 pascals, so the entire range of human hearing spans about six orders of magnitude in this unit.

Everyday objects give a sense of the scale. A sheet of office paper lying flat presses on the desk with about 0.8 pascals. A gentle breeze exerts a few pascals on a wall, and the pressure difference that drives ventilation through a building is typically between ten and fifty. Anything a person can feel as force is already in the thousands.

Prefixed forms carry the real work. Weather uses hectopascals, which are numerically identical to the older millibars, so a forecast reading of 1013 needed no relearning. Engineering uses kilopascals for tyre and fluid pressures, and materials science uses megapascals and gigapascals for strength and stiffness, where one megapascal is one newton per square millimetre.

The pascal also appears wherever a stress rather than a pressure is meant, since the two have the same dimensions. Young's modulus, yield strength and shear stress are all quoted in pascals or their multiples, which is why a single unit spans the pressure in a tyre and the stiffness of steel.

One pascal equals 1 newton per square metre, 0.01 millibars, about 0.0000099 atmospheres, or about 0.000145 pounds per square inch.