Conversion from 2 Yottabits per second to Gigabits per second

Information about the Yottabit per second (Ybit/s)

The yottabit per second is a unit of data transfer rate equal to a thousand zettabits per second. Its symbol is Ybit/s. For thirty years it was the largest rate the metric system could name, and it describes a speed that has no application anywhere: not in engineering, not in research, and not in any forecast that anyone takes seriously.

Its distance from reality is easy to state. Global internet traffic averages roughly one exabit per second, so a yottabit per second is about a million times the combined communication of the entire human species. The largest single link ever built runs at a few hundred terabits per second, which is a ten-billionth of this figure.

The unit is nonetheless properly defined, and that completeness is the point. The metric system's rule is that every prefix combines with every unit without exception, so a reader who has never seen Ybit/s can decode it from the prefix alone. A system with gaps would need a table of which combinations are legal, and a table is exactly what a rule-based system exists to avoid.

There is a physical way to think about the number. A yottabit per second is 125 zettaoctets per second, and the total quantity of data humanity has ever stored is a few hundred zettaoctets. A link at this rate would therefore transmit the entire accumulated information of the species in a couple of seconds. No such body of data exists in one place to be sent, and nothing at the far end could receive it.

The prefix yotta was adopted in 1991 alongside zetta, at a conference that also had to consider which letters remained free. It stood at the top of the metric ladder until 2022, when ronna and quetta were added above it, partly because data quantities were beginning to approach the old ceiling. Rates have not followed quantities upward at the same pace.

For a converter, handling the unit is a matter of consistency rather than utility. A tool that converts every metric prefix correctly does not need to decide which of them anyone will use, and a figure written in yottabits per second — however unlikely — converts by the same rule as any other.

One yottabit per second equals 1,000 zettabits per second, 125 zettaoctets per second, or about 0.8272 yobibits per second.

Information about the Gigabit per second (Gbit/s)

The gigabit per second is a unit of data transfer rate equal to one thousand million bits per second. Its symbol is Gbit/s, often written Gbps. It names the standard of wired local networking and, increasingly, of domestic fibre connections.

Gigabit Ethernet was standardised in 1998 for optical fibre and in 1999 for ordinary twisted-pair copper, and the copper version is what made it universal. It runs a hundred metres over the same cabling that carried the hundred-megabit standard before it, which meant buildings could be upgraded by replacing equipment rather than wiring. That single property fixed the gigabit as the default connection for a generation.

In octets a gigabit per second is 125 megaoctets per second. That is roughly the speed of a good mechanical hard drive and well below a modern solid-state drive, which is why gigabit networking is no longer the bottleneck it once was: the network can now outrun the storage at one end or the other in many common setups.

Domestic fibre services advertise a gigabit routinely, and the figure has become a marketing threshold more than a technical one. Practically no household can saturate it — a gigabit is enough for around two hundred simultaneous high-definition video streams — and the benefit in daily use is not throughput but the absence of congestion, which keeps latency low and steady.

Above the gigabit the ladder continues in the same steps. Ten-gigabit Ethernet is standard between servers and switches in data centres; twenty-five, forty, hundred and four-hundred-gigabit links join racks, buildings and cities. Each is a multiple of the same unit, and each is still counted in bits per second because that is what the optics and the copper actually carry.

Wireless has followed. The later wireless local network standards quote peak rates above a gigabit per second, though those figures assume a single device, ideal conditions and the full width of the channel. Real wireless throughput in a normal home is typically a third to a half of the advertised peak, and the gap widens with every additional device.

One gigabit per second equals 1,000,000,000 bits per second, 125 megaoctets per second, or about 0.9313 gibibits per second.