Conversion from 100 Gigabits per second to Bits per second

Information about the Gigabit per second (Gbit/s)

The gigabit per second is a unit of data transfer rate equal to one thousand million bits per second. Its symbol is Gbit/s, often written Gbps. It names the standard of wired local networking and, increasingly, of domestic fibre connections.

Gigabit Ethernet was standardised in 1998 for optical fibre and in 1999 for ordinary twisted-pair copper, and the copper version is what made it universal. It runs a hundred metres over the same cabling that carried the hundred-megabit standard before it, which meant buildings could be upgraded by replacing equipment rather than wiring. That single property fixed the gigabit as the default connection for a generation.

In octets a gigabit per second is 125 megaoctets per second. That is roughly the speed of a good mechanical hard drive and well below a modern solid-state drive, which is why gigabit networking is no longer the bottleneck it once was: the network can now outrun the storage at one end or the other in many common setups.

Domestic fibre services advertise a gigabit routinely, and the figure has become a marketing threshold more than a technical one. Practically no household can saturate it — a gigabit is enough for around two hundred simultaneous high-definition video streams — and the benefit in daily use is not throughput but the absence of congestion, which keeps latency low and steady.

Above the gigabit the ladder continues in the same steps. Ten-gigabit Ethernet is standard between servers and switches in data centres; twenty-five, forty, hundred and four-hundred-gigabit links join racks, buildings and cities. Each is a multiple of the same unit, and each is still counted in bits per second because that is what the optics and the copper actually carry.

Wireless has followed. The later wireless local network standards quote peak rates above a gigabit per second, though those figures assume a single device, ideal conditions and the full width of the channel. Real wireless throughput in a normal home is typically a third to a half of the advertised peak, and the gap widens with every additional device.

One gigabit per second equals 1,000,000,000 bits per second, 125 megaoctets per second, or about 0.9313 gibibits per second.

Information about the Bit per second (bit/s)

The bit per second is the fundamental unit of data transfer rate. Its symbol is bit/s, often written bps. It counts how many binary decisions a channel carries in one second, and every other unit of transmission speed is a multiple of it.

Because it is a rate, it has the form of a quantity divided by time, exactly like metres per second or litres per second. That makes the arithmetic straightforward: a link running at a given number of bits per second, multiplied by a duration in seconds, gives the total number of bits transferred, and dividing by eight converts that to octets.

The unit must be distinguished from the baud, which counts symbols per second rather than bits. Early modems transmitted one bit per symbol, so the two numbers were the same and the words were used interchangeably. Modern schemes encode several bits in each symbol — by varying phase and amplitude together — so a channel running at 3,000 baud may carry 33,600 bits per second. Only the bit rate describes how much information moves.

Claude Shannon established the theoretical ceiling in 1948. The capacity of a channel in bits per second depends on its bandwidth and on the ratio of signal to noise, and no coding scheme can exceed it. Every advance in modem and radio design since has been an attempt to approach that limit more closely, and modern systems come within a fraction of a decibel of it.

In practice the raw bit rate of a link is never the rate at which useful data arrives. Protocol headers, error-correcting codes, acknowledgements and retransmissions all consume capacity, and the usable fraction is typically 90 to 95 per cent on a wired link and considerably less on a shared wireless one.

Single bits per second are rarely quoted, because almost every channel is faster. The exceptions are deep-space communication, where a probe billions of kilometres away may return data at a few tens of bits per second, and certain low-power sensor networks that transmit a handful of bits at long intervals to preserve battery life.

One bit per second equals 0.125 octets per second, 0.001 kilobits per second, or about 0.0009766 kibibits per second.