Square millimeter (mm²)

The square millimetre is a unit of area equal to one millionth of a square metre, written mm². It is the area of a square one millimetre on a side. It is the standard unit of engineering cross-sections, and two of the most consequential numbers in construction and electrical work are expressed in it.

Electrical cable is the first of those. Outside North America, conductors are specified by their cross-sectional area in square millimetres: 1.5 mm² for lighting circuits, 2.5 mm² for socket outlets, 6 mm² for a cooker, and 16 or 25 mm² for a house supply. Current-carrying capacity follows the area closely, so a 2.5 mm² copper conductor safely carries about twenty amperes in ordinary domestic installation, and the whole of wiring regulation is built on that relationship.

North America uses American Wire Gauge instead, where the numbers run backwards and the steps are not proportional: gauge 14 is about 2.08 mm² and gauge 12 about 3.31. Converting between the two systems is one of the more error-prone tasks in electrical work, because a gauge number carries no information about area until it is looked up.

The second consequential use is stress. One newton per square millimetre is exactly one megapascal, which is why structural drawings state steel and concrete strengths in N/mm². A common structural steel is designated S355 because it yields at 355 newtons per square millimetre, and a concrete grade of C30/37 reaches 30 newtons per square millimetre in cylinder testing. Bolts are rated the same way, using their tensile stress area: an M10 bolt has 58 square millimetres of it.

Electronics measures its products here too. A large processor die covers between 300 and 600 square millimetres, and the cost of a chip is driven directly by that number because a wafer holds a fixed area. A full-frame camera sensor is 864 square millimetres against roughly 30 for a phone camera, which is most of the reason the two behave so differently in low light.

Below the square millimetre the metric ladder continues to the square micrometre, used for transistors and cell biology, but almost nothing in ordinary manufacturing needs to go further. Above it, the square centimetre takes over at a hundred square millimetres.

One square millimetre equals 0.01 square centimetres, 0.000001 square metres, or about 0.00155 square inches.

Square millimeter conversion table