Liter per second (L/s)

The litre per second is a unit of volumetric flow rate equal to one litre passing a point every second. Its symbol is L/s. It is the unit of pumps, drains and ventilation — the scale at which a flow is large enough to be a design problem but small enough to belong to a single building.

A litre per second is a substantial stream. A kitchen tap fully open delivers about a fifth of it, a bath fills at roughly a third, and a fire hose runs at ten to twenty times as much. In visual terms it is a jet about as thick as a thumb moving briskly, and it would fill a domestic bath in about two minutes.

Building services are specified in this unit throughout Europe. Ventilation rates are given as litres per second per person — around eight to ten in an office, more in a room where people cook or exercise — and a designer multiplies that figure by the number of occupants to size the fans and the ductwork. The same unit describes rainwater drainage, where a roof's area and the local rainfall intensity together determine the flow a downpipe must carry.

Pumps are rated the same way. A domestic circulating pump moves a fraction of a litre per second, a borehole pump a few, and a large sewage pump hundreds. Because the power a pump needs is the flow multiplied by the pressure it must overcome, this figure sits at the centre of every pump calculation.

For gases the unit describes compressors and blowers, though there the volume depends on pressure and temperature and so must be stated at defined conditions. A compressor rated at fifty litres per second of free air is measured with the air at atmospheric pressure, and the same machine moving compressed air is shifting a far smaller volume.

A litre per second is a thousandth of a cubic metre per second, which is why hydrologists and building engineers rarely use the same unit even when they are describing the same water. A river carrying a cubic metre per second is carrying a thousand litres per second, and both figures are correct.

One litre per second equals 1,000 millilitres per second, 60 litres per minute, or about 0.0353 cubic feet per second.

Liter per second conversion table